6 GHz RF Signal Generator Manufacturer,Supplier and Exporter in India
Product Code : EL-RSG-10402
Jlab Export is a leading 6 GHz RF Signal Generator Manufacturer,and suppliers in India
6 GHz RF Signal Generator (code EL-RSG-10402) is a 2U-high RF source with a top frequency of 6 GHz and an output level adjustable from −130 dBm to +13 dBm. AM, FM, phase and pulse modulation are standard, I/Q modulation and I/Q baseband output are options, and it can be run remotely over USB, LAN or GPIB with SCPI commands. JLab builds this 6 GHz signal generator in Ambala, India.
Specifications
| Parameter | Detail |
|---|---|
| Maximum frequency | 6 GHz |
| Output level | −130 dBm to +13 dBm |
| Amplitude accuracy | <0.5 dB (typical) |
| Phase noise | <−110 dBc/Hz at 20 kHz offset (typical) |
| Analog modulation | AM, FM and ΦM as standard; internal or external source |
| Pulse modulation | Standard, on/off ratio up to 80 dB; pulse train generator as an option |
| I/Q options | I/Q modulation; I/Q baseband output |
| Reference clock | 0.5 ppm internal as standard; 5 ppb high-stability clock as an option |
| Remote control | USB, LAN and GPIB; SCPI command set |
| Housing | 2U height; rack mount kit available |
| Quality check | Each signal generator is visually inspected before dispatch |
| Pack quantity | Each (sold individually) |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 7–10 working days |
| Product code | EL-RSG-10402 |
| Manufacturer | Jain Laboratory Instruments Pvt Ltd (JLab) — OEM |
| Country of origin | India (made in Ambala, Haryana) |
Output Level in dBm and How It Is Set
dBm states power relative to 1 mW: 0 dBm is 1 mW, +13 dBm is about 20 mW, and each 10 dB step down divides the power by ten, so −130 dBm is an extremely weak signal. The level is set by an electronic attenuator, which has no mechanical contacts to wear. An automatic flatness calibration, run under power-meter control, corrects the level for the cables, attenuators and amplifiers in a test system, and amplitude accuracy is better than 0.5 dB (typical).
Modulation, Phase Noise and the Reference Clock
Every modulation type works from an internal or an external modulating signal. Pulse modulation switches the carrier on and off, with the off state as much as 80 dB below the on state. Phase noise below −110 dBc/Hz at a 20 kHz offset (typical) is the noise power in a 1 Hz bandwidth beside the carrier, stated relative to the carrier. The internal reference clock is rated 0.5 ppm, and a 5 ppb high-stability clock can be fitted instead.
Other RF Generators and a Spectrum Analyzer
- 3 GHz RF Signal Generator — 9 kHz to 3 GHz source with up to +20 dBm output.
- 150 MHz RF Signal Generator — dial-tuned 100 kHz–150 MHz generator with amplitude modulation.
- 3.3GHz Color Spectrum Analyzer for EMI — battery-powered analyser with quasi-peak and average detection.
The RF Signal Generator range sits within Test and Measurement Equipment.
Request a Quote
Use Add To Cart or the contact page, stating the quantity, any options wanted (I/Q, pulse train, high-stability clock, rack kit) and the delivery address.
Last updated: 30 October 2026
