Desoldering Station Manufacturer,Supplier and Exporter in India
Product Code : EL-SADS-10479
Jlab Export is a leading Desoldering Station Manufacturer,and suppliers in India
Desoldering Station (code EL-SADS-10479) is a temperature-controlled unit for clearing solder from joints so that components can be removed or replaced, with microcontroller control to ±1 °C and keypad setting. It keeps its last set value, uses a burn-proof silicone cable heat resistant up to 600 °C, and can be password locked. Ambala, India is where JLab manufactures this desoldering station.
Specifications
| Parameter | Detail |
|---|---|
| Station type | Temperature-controlled desoldering station |
| Temperature control | Microcontroller based, accuracy ±1 °C |
| Temperature setting | Increase and decrease keys; read temperature shown two seconds after setting |
| Calibration | Digital, through the microcontroller |
| Memory | Last set temperature stored |
| Cable | Burn-proof silicone, heat resistant up to 600 °C |
| Password lock | Available for bulk customers |
| Quality check | Each desoldering station is visually inspected before dispatch |
| Pack quantity | Each (sold individually) |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 7–10 working days |
| Product code | EL-SADS-10479 |
| Manufacturer | Jain Laboratory Instruments Pvt Ltd (JLab) — OEM |
| Country of origin | India (made in Ambala, Haryana) |
How Desoldering Differs from Soldering
Soldering adds solder to make a joint; desoldering takes it away again. The heated desoldering tool melts the joint and the molten solder is drawn off by vacuum, leaving the lead free in its hole so the part can be pulled without tearing the pad. A steady, known temperature matters here because the joint must melt right through before the solder is drawn off.
Keypad Setting and Digital Calibration
The required temperature is entered with the increase and decrease keys. By default the display changes back to the read value two seconds after setting, so the operator can watch the tool reach temperature. Calibration is done digitally by the microcontroller rather than with analogue trimming parts, and the last setting stays in memory. For bulk customers a password can stop operators altering it.
Other Stations and a Hand Desolder Pump
- Soldering Station — for making the new joints after a part is replaced.
- Soldering and Desoldering Stations — handles both soldering and desoldering work.
- Digital Rework Station — hot-air unit with an automatic cooling run at switch-off.
- Desolder Pump — one-handed ABS suction pump, a manual alternative.
Similar bench units are grouped under Soldering and Desoldering Station in the Test and Measurement Equipment section.
Request a Quote
Send the quantity and the delivery town through the contact page, or place the desoldering station in your enquiry with Add To Cart.
Last updated: 30 October 2026
