Electric Oven Manufacturer,Supplier and Exporter in India
Product Code : EL-GLE-13231
Jlab Export is a leading Electric Oven Manufacturer,and suppliers in India
Electric Oven (code EL-GLE-13231) is a laboratory heating oven, model JL205, that can be set from +20 to +300 °C and reads its chamber temperature with a Pt100 sensor in a 4-wire circuit. The stainless steel interior holds at least 30 litres, takes up to three grids and carries 60 kg in all. JLab manufactures this oven in Ambala, India.
Specifications
| Parameter | Detail |
|---|---|
| Model | JL205 |
| Setting temperature range | +20 to +300 °C |
| Temperature sensor | Pt100, 4-wire circuit |
| Chamber volume | Minimum 30 litres |
| Interior | Stainless steel, deep-drawn ribbing, heating on four sides |
| Internals | Electropolished stainless steel grids, up to 3 |
| Maximum chamber load | 60 kg |
| Maximum load per internal | 20 kg |
| Door | Fully insulated stainless steel, 2-point compression lock |
| Quality check | Each oven is visually inspected before dispatch |
| Pack quantity | Each (sold individually) |
| Minimum order quantity | 5 units |
| Dispatch time | Usually 7–10 working days |
| Product code | EL-GLE-13231 |
| Manufacturer | Jain Laboratory Instruments Pvt Ltd (JLab) — OEM |
| Country of origin | India (made in Ambala, Haryana) |
Chamber, Grids and Loading
The interior is stainless steel, stiffened by deep-drawn ribbing and easy to wipe clean. Its heating is built into four sides of the chamber, protected behind the walls, so warmth reaches the load from all round instead of from a single element. Up to three electropolished stainless steel grids fit inside; each grid takes up to 20 kg, and the whole chamber up to 60 kg, which covers trays of glassware, soil or sand samples and crucibles for drying.
Temperature Measurement and Door
A 4-wire Pt100 circuit keeps the resistance of the sensor leads out of the measurement, so the length of the leads does not shift the reading. The fully insulated stainless steel door closes with a 2-point compression lock that pulls it tight against the front of the chamber.
Installation Requirements
Leave at least 15 cm between the wall and the back of the oven, at least 20 cm to the ceiling and at least 5 cm at each side from walls or other appliances, so heat can escape from the casing. Install it no higher than 2,000 m above sea level, in a room between +5 and +40 °C with relative humidity of at most 80 %, non-condensing.
Related Items
- Electric Oven — 47 L model with PID control, LED display and a glass window.
- Desiccator (180 mm) — cools dried samples over a porcelain plate before weighing.
- Weighing Bottle — borosilicate bottle for the precise weighing of solids.
- Analytical Balance (Digital) — 0.1 mg readability for weighing samples after drying.
More bench equipment is in General Lab Equipment.
Request a Quote
Ask for a quotation through Add To Cart or the contact page, giving the model JL205, the number of ovens and the delivery location.
Last updated: 26 October 2026