• +91-85699-09696

Hydrocollator Hot Pack Manufacturer,Supplier and Exporter in India

Hydrocollator Hot Pack

Product Code : EL-PE-3848
Jlab Export is a leading Hydrocollator Hot Pack Manufacturer,and suppliers in India

Silica gel hot packs soak and heat in the stainless steel water chamber of this unit, ready to be lifted out and wrapped for moist heat. Concealed air heaters warm the water without touching it or the chamber, under thermostatic control. A mains indicator and a temperature-maintain indicator show the unit’s state. The packs come in different shapes and sizes.

Specifications

PacksSilica gel, different shapes and sizes
ChamberStainless steel
HeatersConcealed air heaters, not in direct contact with the water or chamber
ControlThermostatic
IndicatorsMains and temperature-maintain
Minimum order quantity1 unit
Dispatch timeUsually 14–18 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Hot Pack Practicals for Students

A practical often begins with the morning check that a department keeps on record. Students confirm that every pack is under water, switch on, and note when the mains lamp lights and when the temperature-maintain lamp comes on. They then read the water with a Calibrateable Digital Thermometer and log the reading beside the thermostat setting.

Next comes handling. Each student lifts a pack out with stainless steel Tongs and lets it drain over the chamber. They wrap it in layers of cotton Towel as the department procedure sets out. The wrapped pack is then laid on a manikin or the bench, and nobody handles a pack bare.

Frequently Asked Questions

What do the two indicator lamps tell you?
The mains indicator shows that the unit has power. The temperature-maintain indicator shows the thermostat at work holding the water at its set level. If the water stays cold while the mains lamp is on, have the heaters and thermostat checked.

How often should the water be changed and the chamber cleaned?
Follow the department’s own routine and record it. Change it when the water turns cloudy or smells, or residue settles on the chamber floor. Unplug the unit, drain it, wipe out and rinse the chamber, and refill with clean water.

When does a silica gel pack need replacing?
Take a pack out of use when its cover splits, gel seeps through the fabric, or dark spots appear that do not wash out. A pack that has gone stiff and lumpy also heats unevenly and should be replaced.

Why must the packs stay under water?
A pack left above the water line dries out and heats unevenly, with the exposed part cooler than the rest. Keep the water topped up so every pack is covered, and never switch the unit on with the chamber low or empty.

Why do the heaters not touch the water?
The air heaters are concealed outside the water and the chamber, so residue cannot build up on them and the heating parts stay out of the wet zone. The stainless steel chamber resists the oxidation that constant use with water would cause.

Other Thermotherapy Equipment

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 13 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us