Vortex Shaker Manufacturer,Supplier and Exporter in India
Product Code : EL-S-2069
Jlab Export is a leading Vortex Shaker Manufacturer,and suppliers in India
Mixing a solution in a test tube takes seconds on this vortex shaker. A short eccentric stroke motor moves the head in a tight circle. Liquid in a tube, small flask or centrifuge tube pressed onto it spins into a vortex. A speed control sets how hard it shakes, and the 150 x 150 mm housing has a stoving enamel finish.
Specifications
| Housing | 150 x 150 mm, stoving enamel finish |
| Drive | Short eccentric stroke motor for vigorous agitation |
| Speed | Regulated by a speed control device |
| Vessels | Test tubes, small flasks and centrifuge tubes |
| Power supply | 220 V AC, 50 Hz, single phase |
| Minimum order quantity | 5 units |
| Dispatch time | Usually 7–10 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Lab Exercises for Chemistry and Biology Students
When students make serial dilutions of a dye or a bacterial suspension, each tube must be mixed before the next transfer. A few seconds on the shaker does it, and the tubes then wait in a Test Tube Rack. Poor mixing shows up later as an uneven line when the dilutions are read on a colorimeter.
In biochemistry, students re-suspend a cell or protein pellet after centrifuging in a Centrifuge Tube Conical Bottom. They also mix a sample with its reagent in Laboratory Test Tubes before a colour test. Holding the tube near the top and pressing lightly gives a steady vortex without splashing.
Frequently Asked Questions
How do I use a vortex shaker without spilling?
Fill the tube no more than about a third and set a low speed. Then press the tube bottom onto the head and raise the speed until a vortex forms. Cap the tube first whenever it holds anything you must not spray.
What vessels can it mix?
It is made for test tubes, centrifuge tubes and small flasks. Larger flasks and beakers mix better on a flask shaker or a magnetic stirrer, because the head cannot swirl a heavy vessel well.
How does it differ from the Vortex Shaker (Test Tube Shaker) JLab?
Both swirl liquid in tubes by an eccentric drive. This model has a 150 x 150 mm housing and a speed control device. The Test Tube Shaker JLab model has a rubber buffer on top and a thyristor speed controller, and the tube position varies its intensity.
Why will a pellet not come loose?
A firm pellet may need a few short pulses at higher speed, or a flick of the tube first. Adding the liquid down the tube wall onto the pellet also helps it lift before vortexing.
How should I look after the shaker?
Unplug it before cleaning. Wipe spills off the head and the enamel housing with a damp cloth. Stand it on a firm, level bench so it does not creep at high speed.
Other Mixers and Shakers
- Vortex Shaker (Test Tube Shaker) JLab (rubber buffer and thyristor control)
- Vortex Mixer (touch and continuous modes)
- Mini Rotary Flask Shaker
- Rotary Shaker
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
