• +91-85699-09696

Vortex Shaker (Test Tube Shaker) JLab Manufacturer,Supplier and Exporter in India

Vortex Shaker (Test Tube Shaker) JLab

Product Code : EL-S-6522
Jlab Export is a leading Vortex Shaker (Test Tube Shaker) JLab Manufacturer,and suppliers in India

The top of this test tube shaker is a rubber buffer, driven by an eccentric drive from the motor inside an enamel-finished housing. A tube held against the buffer vibrates rapidly, so the liquid in it mixes quickly and evenly. A thyristor speed controller sets the oscillations, and moving the tube on the buffer changes the strength of agitation.

Specifications

Mixing headRubber buffer on an eccentric drive
Speed controlThyristorised, adjusts the degree of oscillation
AgitationSet by speed and by the tube position on the buffer
HousingEnamel finished, contains the motor
VesselsTest tubes, small flasks and bottles
Power supply220/230 V AC
Minimum order quantity5 units
Dispatch timeUsually 7–10 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Practicals for Microbiology and School Science

For a soil or water plate count, microbiology students make tenfold dilutions in Test Tube with Screw Cap (Polypropylene) tubes. Each tube is mixed on the buffer before the next transfer with Graduated Pipettes, Class B Soda Glass JLab. The last dilutions are spread on Petri Dish (Polypropylene) plates, and a well-mixed series gives counts that fall in step from plate to plate.

In school chemistry, students dissolve a salt or shake two liquids together to see whether they mix. A teacher can show how moving the tube on the buffer changes the shaking, and why a capped tube is used for anything that must not splash.

Frequently Asked Questions

How should the tube be held on the buffer?
Hold it near the top between thumb and fingers and rest its bottom on the rubber buffer. Light pressure is enough. Changing the angle and position of the tube against the buffer changes how strongly the liquid moves.

How do I set the strength of mixing?
Turn the thyristor speed controller to raise or lower the oscillations, then fine-tune by moving the tube on the buffer. Start low with full or uncapped tubes, and go up only as far as the liquid stays well below the rim.

Can it mix protein or cell samples without damage?
Short, gentle mixing suits most samples. Long, hard shaking can froth protein solutions and break fragile cells or long DNA. Those samples are often mixed by gentle swirling, or by turning the tube over a few times.

Can it mix small bottles as well as tubes?
Yes. The unit is meant for test tubes, small flasks and bottles. Hold a bottle firmly by its neck and keep it upright on the buffer, with the cap closed if the contents must not spill.

Other Tube and Flask Mixers

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us