Drill Press Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-9219
Jlab Export is a leading Drill Press Manufacturer,and suppliers in India
A drill press drills holes square to the work, with the spindle fed down by a hand lever while the work stays clamped on the table. This bench model has 16 spindle speeds from 215 to 3250 rpm, a 16 mm chuck, an MT 2 spindle taper and a 0.5 hp motor. The round table is 350 mm across and is carried on an 80 mm column.
Specifications
| Type | Bench drill press |
| Spindle speeds | 16 speeds, 215–3250 rpm |
| Chuck | 16 mm |
| Spindle taper | MT 2 |
| Motor | 0.5 hp |
| Column diameter | 80 mm |
| Working table | 350 mm diameter |
| Overall height | 1045 mm |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice on the Drill Press
Drilling and countersinking a mild steel plate is a standard fitting job. Students mark out the hole centres, dot them with a Punch Tool and clamp the plate in a Drilling Machine Vice on the table. A small pilot hole comes first. The hole is then opened to size with a bit from the HSS Universal Drill Bit Set. The top edge is countersunk for a screw head at a low speed.
Teachers use the speed range to show how speed falls as drill size rises. A small bit runs near the top of the range and a large one near the bottom. In the carpentry shop the same machine bores dowel holes with the Dowel Drill Bit Set.
Frequently Asked Questions
Which speed should I use?
The 16 speeds run from 215 to 3250 rpm. Use the low end for large drills, hard steel and countersinking, and the high end for small drills and soft materials such as wood, aluminium and plastic.
What size of drill will the chuck hold?
The chuck takes straight-shank drills up to 16 mm. The spindle has an MT 2 taper, so tools with an MT 2 taper shank can be fitted in the spindle itself once the chuck is taken off.
How should the work be held?
Clamp it in a machine vice or bolt it to the table, never hold it by hand. A drill that snatches can spin loose work round with it. Put a scrap block under the work so the drill can break through without touching the table.
Does it need a floor stand?
No. It is a bench type machine, 1045 mm tall overall, and stands on a strong bench or cabinet. Bolt it down so it cannot tip when long work is drilled.
What safety rules apply when drilling?
Remove the chuck key before starting, tie back hair and loose clothing, and wear safety glasses. Do not wear gloves near the turning spindle, and clear chips with a brush only after the spindle has stopped.
Other Drilling Machines
- Electric Drill (Bench Drill) (three-phase, MT3 spindle)
- Pillar Drill Machine
- Radial Drilling Machine
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
