Electric Drill (Bench Drill) Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-13016
Jlab Export is a leading Electric Drill (Bench Drill) Manufacturer,and suppliers in India
Built for fitting and machine shops, this drilling machine makes holes up to 25 mm diameter in steel. A 750 W, 400 V three phase motor drives the MT3 spindle through 12 speeds from 200 to 2440 rpm. The 330 x 290 mm table has 14 mm T-slots, tilts 45 degrees each way and turns a full circle round the column.
Specifications
| Motor | 750 W, 400 V three phase, 50 Hz, right and left hand rotation |
| Drilling capacity in steel | 25 mm diameter |
| Spindle taper | MT3 |
| Spindle speeds | 12 steps, 200–2440 rpm |
| Sleeve travel | 85 mm |
| Working range | 210 mm |
| Table | 330 x 290 mm, 14 mm T-slots, tilts ±45°, swivels 360° |
| Max distance spindle to table / foot | 720 mm / 1230 mm |
| Drill chuck | Quick action, 3–16 mm |
| Safety switch | Low voltage release, emergency stop button |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Reading the Table and Spindle Figures
Sleeve travel of 85 mm is the deepest hole the spindle can feed in one stroke. With the table at its lowest, the spindle nose stands up to 720 mm above it, room for tall work plus the chuck and drill. Swing the table aside and that distance grows to 1230 mm at the foot, for tall work stood on the base.
Fitting Shop Practicals on the Bench Drill
Trainees mark hole centres on a mild steel plate with a Single Ended Scriber and drill a small pilot hole at a high speed step. They then open each hole in stages with bits from the HSS Universal Drill Bit Set, moving down the speed steps as the drill gets bigger.
Tapping drill holes are the next exercise. Students drill each hole to the tapping size for the thread, then cut the thread with the Tap & Die Set, Metric Small. With the table tilted, they also drill an angled hole and check that the work stays clamped through the cut.
Frequently Asked Questions
Why does it need a three phase supply?
The 750 W motor is wound for 400 V three phase, the normal supply in ITI and polytechnic machine shops. A building with single phase power only would need a three phase connection for it.
How do I choose the spindle speed?
Small drills run fast and large drills slow. Use the top steps, towards 2440 rpm, for small holes and the bottom steps, towards 200 rpm, for holes near 25 mm in steel. Harder metals need lower speeds and cutting fluid.
What does MT3 mean?
MT3 is Morse taper number 3, the tapered bore in the spindle. Taper shank drills and the chuck arbor fit straight into it and are held by friction. A drift through the slot in the spindle knocks them out.
When is left hand rotation used?
Mainly for tapping. The tap is fed in with normal right hand rotation, then the spindle is reversed to back it out of the thread. Plain drilling always uses right hand rotation.
What do the safety switch features do?
The low voltage release stops the motor from restarting by itself when power returns after a cut. The emergency stop button cuts the power at once when it is pressed.
Other Drills and Drilling Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
