Claw Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-12979
Jlab Export is a leading Claw Manufacturer,and suppliers in India
This claw is a claw hammer for nailing work. Its face drives nails, and the split claw at the back pulls out bent or misplaced ones. It is made of forged steel and weighs 450 g. The alloy steel handle has a shock reduction grip that takes some of the jar out of each blow.
Specifications
| Material | Forged steel |
| Handle | Alloy steel |
| Weight | 450 g |
| Grip | Shock reduction |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Carpentry Workshop Practice with the Claw
Students nail together a small box or frame at the Work Bench with galvanized Nails. Each nail is started with light taps while the fingers hold it. Then the hand comes away and the nail is driven with full blows. The last blow leaves the head flush without the face denting the wood.
A nail that bends is pulled with the claw: slide the claw under the head and rock the handle back. A scrap block under the hammer head adds lift and protects the surface. Teachers can compare this with the Pliers, nail pincers that grip a head sitting too low for the claw.
Frequently Asked Questions
Is this a claw hammer or a nail bar?
It is a claw hammer: one tool with a striking face for driving nails and a split claw for pulling them. A nail bar or crowbar has no striking face and is used for heavy levering.
Why does a nail bend while I drive it?
Usually the face meets the nail at an angle, or a greasy face glances off it. Strike square, keep the face clean and drill a small pilot hole in hardwood or near the end of a board.
What does the shock reduction grip do?
It soaks up part of the jar that runs up a steel handle at each blow. That makes a long nailing job less tiring for the hand and wrist.
Can it be used on chisels or punches?
A claw hammer is made for nails. Strike wood chisels with a wooden mallet, and drive cold chisels and punches with a ball peen or club hammer.
Other Hammers for the Tool Board
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
