• +91-85699-09696

Mallet Hammer Manufacturer,Supplier and Exporter in India

Image Not Found .

Product Code : EL-WT-12977
Jlab Export is a leading Mallet Hammer Manufacturer,and suppliers in India

A rubber mallet gives a firm but soft blow that moves or shapes a part without denting it. This mallet hammer has a solid rubber head and weighs 450 g, with a non-slip grip on the handle. It is the tool for folding sheet, seating parts and knocking frames together.

Specifications

HeadSolid rubber
Weight450 g
GripNon-slip
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Sheet Metal and Assembly Workshop Practice

Sheet metal students cut a tray blank from Aluminium Sheet with the Straight Metal Tin Snips. They grip it in the Bench Vice with the bend line level with the jaws, then fold the edge over with the mallet. Working along the bend a little at a time keeps the fold straight, and the rubber leaves no dents.

In fitting and assembly work, the mallet taps a part into line in the vice and seats a shaft or pin. It also closes up a tight joint without burring the faces. Teachers can strike a scrap of sheet once with a steel hammer and once with the mallet, and let students compare the marks.

Frequently Asked Questions

Can the mallet be used to bed paving blocks?
Yes, tapping blocks down onto a sand or mortar bed is a common use. Use light blows near the middle of the block, since one hard strike can chip an edge. A block that will not settle level is lifted and the bed put right.

Is it the same as a dead blow hammer?
No. A dead blow hammer has a hollow head part filled with shot or sand, which cuts the rebound and puts more of the blow into the work. This mallet has a solid rubber head, so it strikes more softly. It suits sheet, frames and fitted parts.

Why does the mallet bounce back?
Rubber is elastic, so part of each blow springs back. Hold the handle firmly, strike square to the work and let the 450 g head do the work rather than swinging harder.

Will the rubber leave marks?
It does not dent metal or wood. Dark rubber can leave scuff marks on pale or painted surfaces, which usually wipe off. A clean cloth over a finished face avoids them.

Other Striking Tools in the Range

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us