Aluminium Sheet Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-13083
Jlab Export is a leading Aluminium Sheet Manufacturer,and suppliers in India
Aluminium sheet is the easiest metal for students to cut, bend and rivet by hand. This flat sheet is 0.8 mm thick and comes in a standard sheet size, ready to be marked out for trays, boxes, brackets and test pieces. It is light, does not rust the way steel does, and takes scribed lines clearly.
Specifications
| Material | Aluminium |
| Thickness | 0.8 mm |
| Form | Flat sheet |
| Size | Standard sheet |
| Colour | Silver |
| Minimum order quantity | 50 units |
| Dispatch time | Usually 3–5 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Sheet Metal Practicals with Aluminium
A small open tray is the classic first sheet-metal job. Students mark the blank and the corner notches with a Scriber and an Engineers Square, then cut along the lines with the Aviation Tin Snips. They fold the sides up over a hardwood block held in the vice, file off the burrs and join the corners with pop rivets set by the Riveter.
A scoop or a small funnel makes a good second task. It teaches curved cuts with the snips and shows how a cone is laid out flat before it is rolled.
Frequently Asked Questions
Can 0.8 mm aluminium be cut with hand snips?
Yes. Sheet of this thickness cuts cleanly with tin snips or aviation snips, and a hacksaw with a fine blade handles short straight cuts. Hold the sheet close to the line so it does not buckle.
Will aluminium sheet crack when it is bent?
Soft grades fold tightly without trouble, while harder grades can crack on a sharp bend. Use as large a bend radius as the job allows, and fold across the rolling direction where you can.
Can aluminium sheet be soldered?
Not with ordinary tin-lead solder. Aluminium carries a tough oxide film that stops solder from wetting the surface. Riveting is the usual joint in school workshops, and special aluminium solders and fluxes exist for repair work.
How does it compare with galvanized steel sheet?
Aluminium weighs about a third as much as steel, cuts and bends more easily and is not magnetic. The 1 mm Galvanized Steel Sheet is stiffer and heavier, and it can be soft soldered with an active flux.
Other Sheet Metal Tools and Stock
- Straight Metal Tin Snips
- Rivet Set (for drawing up rivets)
- Mallet Hammer (solid rubber head)
- Aluminum Rod (brazing rod pack)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
