• +91-85699-09696

Masonry Hole Saw Manufacturer,Supplier and Exporter in India

Image Not Found .

Product Code : EL-WT-13002
Jlab Export is a leading Masonry Hole Saw Manufacturer,and suppliers in India

Carbide-tipped teeth let these hole saws cut stone, which would quickly blunt the teeth of an ordinary saw. The kit holds five cutters of 30, 40, 65, 80 and 100 mm. With them come a 300 mm SDS plus shank, a 300 mm SDS max shank and two 10 mm drill bits, all in an aluminium box. The two shank types fit the two common rotary hammer chucks.

Specifications

Cutter materialCarbide tipped metal
Cutter diameters30, 40, 65, 80 and 100 mm
Shanks300 mm SDS plus and 300 mm SDS max
Drill bits2 x 10 mm
CaseAluminium box
Kit includes10 pieces
Suitable forWood, aluminium, plastic and stone
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Construction Lab Practicals with Core Cutters

In a construction or plumbing lab, students cut holes through stone or masonry for pipes and cable ducts. They mark the hole centre, check its position with a Tape Measure, and fit a cutter and a 10 mm drill bit to the shank. The SDS plus shank goes into a Rotary Hammer Drill, which has an SDS-plus chuck.

The 10 mm bit starts the hole and holds the cutter on its mark until the teeth have cut a groove. Hammer action is used only in stone and masonry. For wood, plastic or aluminium, students switch the drill to rotation only, and they wear Safety Goggles with Polycarbonate Lens throughout.

Frequently Asked Questions

Which drill do I need for these cutters?
A rotary hammer drill with an SDS plus or SDS max chuck. The kit has one 300 mm shank of each type, so the cutters suit both chuck systems. A drill with an ordinary keyed chuck cannot hold these shanks.

When should I use hammer action?
Use hammer action with rotation in stone and masonry. Switch to rotation only for wood, plastic or aluminium, where hammering would tear the material and can chip the carbide tips.

What are the 10 mm drill bits for?
They are the centre drills. Each one starts the hole at the marked point and guides the cutter until its teeth bite. A worn or bent centre drill lets the cutter wander, and there are two in the kit.

How do I choose a cutter size for a pipe?
Pick a cutter a little larger than the pipe or duct, to leave room for a sleeve or sealant. The kit covers holes of 30, 40, 65, 80 and 100 mm.

Other Drilling and Hole Cutting Tools

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us