Hole Saw Kit Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-13001
Jlab Export is a leading Hole Saw Kit Manufacturer,and suppliers in India
A hole saw cuts a round hole by sawing only a thin ring of material. It therefore needs far less power than a twist drill of the same size. This 10 piece cobalt kit has six saws from 3/4 to 2 inch, two arbors of 1/4 and 7/16 inch, a hex key and a plastic case. It cuts wood, aluminium, plastic and metal.
Specifications
| Material | Cobalt |
| Hole saws | 6: 3/4, 7/8, 1.125, 1.5, 1.75 and 2 inch |
| Arbors | 2: 1/4 and 7/16 inch |
| Also included | Hex key and plastic case |
| Kit includes | 10 pieces |
| Suitable for | Wood, aluminium, plastic and metal |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice with Hole Saws
In electrical installation and fabrication labs, students cut cable entry holes in boxes and panels made from Aluminium Sheet or Galvanized Steel Sheet. They mark and centre punch the hole position and fit the saw to its arbor, tightening it with the hex key. The cut is made at low speed in a Portable Electric Drill or the Electric Drill (Bench Drill).
In metal, a few drops of cutting oil and a steady feed keep the teeth from overheating. Teachers can show that bigger saws must turn more slowly, because the teeth on a larger rim travel faster at the same spindle speed.
Frequently Asked Questions
What drill speed should I use?
Run the saw slowly: the larger the saw, the lower the speed. Metal needs a lower speed than wood or plastic. If the saw smokes or squeals, or the teeth darken, slow down and add cutting oil.
How do I fit a hole saw to the arbor?
Fit the saw onto the arbor that suits it and tighten it with the hex key from the kit. Spin the drill briefly to check that the saw runs true before you start the cut.
How do I get the plug out of the saw?
Unplug the drill first. Take the saw off the arbor if needed and push the plug out from behind with a screwdriver or a rod. Wear gloves, as the plug and the teeth may be hot and sharp.
Can these saws cut stone or tile?
No. They are for wood, aluminium, plastic and metal. For stone, use carbide-tipped cutters such as the Masonry Hole Saw kit, run in a rotary hammer drill.
Other Drilling Tools and Bit Sets
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026