Chisel Set Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-12980
Jlab Export is a leading Chisel Set Manufacturer,and suppliers in India
Three wood chisels make up this set, in ½, ¾ and 1 inch widths. They have steel blades and wooden handles, and they pare and chop timber when joints are cut, housings cleaned out and shoulders trimmed. The three widths cover narrow slots through to wide recesses.
Specifications
| Pieces | 3 |
| Widths | ½, ¾ and 1 inch |
| Blades | Steel |
| Handles | Wood |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Joint Cutting Practicals for Carpentry Students
A cross halving joint is often the first chisel job. Students mark the width and depth with a Square and saw down the shoulders to the depth line. They chop out the waste from both sides with the 1 inch chisel, struck with the Wood Hammer, and pare the bottom flat. The ½ inch chisel cleans the corners and cuts small mortises.
The work is clamped to the Work Bench and never held in the other hand, and both hands stay behind the edge. Teachers can show that with the bevel down the chisel rides up out of the cut, while with the flat back down it pares a level surface.
Frequently Asked Questions
Which chisel width should I use?
Match the chisel to the cut. The 1 inch chisel clears waste fast in wide housings and halvings, the ¾ inch suits medium joints, and the ½ inch reaches into narrow slots, corners and small mortises.
Can I hit the handles with a steel hammer?
No. Wooden handles are struck with a wooden mallet, which spreads the blow. A steel hammer bruises the end of the handle and soon splits it. Light paring needs only hand pressure.
How do I sharpen a wood chisel?
Flatten the back on a sharpening stone first. Then hone the bevel at a steady angle until a fine burr forms along the edge, and remove the burr with a few strokes on the flat back.
Can these chisels cut metal?
No. Wood chisel edges are thin and would chip. Metal is cut with a cold chisel such as the Flat Cold Chisel, struck with a hammer.
How should the chisels be stored?
Keep the edges apart so they do not knock against other tools, for example in a rack or a tool roll. Wipe the blades dry and give them a light film of oil if the workshop is damp.
Other Woodworking Hand Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
