Portable Angle Grinder Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-13014
Jlab Export is a leading Portable Angle Grinder Manufacturer,and suppliers in India
Fitted with 125 mm discs on its M14 spindle, this mains angle grinder cuts steel sections, grinds weld beads flush and cleans up edges. It runs on 220 V single phase at 50 Hz, reaches a top speed of 11800 rpm and cuts to a depth of 33 mm.
Specifications
| Supply | 220 V, single phase, 50 Hz |
| Disc diameter | 125 mm, grinding or cutting |
| Spindle thread | M14 |
| Maximum speed | 11800 rpm |
| Maximum cutting depth | 33 mm |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice in Cutting and Grinding
For a welded frame, fabrication trainees cut a V notch in one flange of a length of Angle Iron. They then bend the bar so the notch closes into a square corner. Before a butt joint on plate, they grind a bevel on each edge so the weld from the Arc Welding Machine can reach the root. Afterwards they grind the cap flush.
Finishing work follows: rust and mill scale are ground off the frame and the bare steel is coated with Anti-Rust Paint the same day. Teachers use these jobs to show disc choice, guard position and a two-handed grip.
Frequently Asked Questions
Can I fit a disc larger than 125 mm?
No. The guard and the speed are matched to 125 mm discs. A larger disc would run partly outside the guard, and its rim would travel faster than it is rated for.
What does M14 mean?
M14 is the metric thread on the spindle, 14 mm across. The flange nut screws onto it to clamp the disc, and accessories with an M14 thread, such as wire cup brushes, screw straight on.
Does the disc speed rating matter?
Yes. Every disc is marked with a maximum speed. Fit only discs rated at or above 11800 rpm on this grinder, and check each disc for cracks or chips before fitting it.
How deep can it cut?
Up to 33 mm, which is how far the 125 mm disc reaches past the flange and guard. For thicker bar, cut from both sides or use a Power Hacksaw Machine.
How should the grinder be held?
Use both hands, with the side handle fitted, and stand to one side of the disc. Let the disc reach full speed before it touches the work, and keep the guard between the disc and your body.
Other Grinders and Abrasive Tools
- Cordless Portable Angle Grinder
- Large Angle Grinder (takes larger discs)
- Pedestal Grinder
- Grinding Goggles
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
