Blower Fans Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-13021
Jlab Export is a leading Blower Fans Manufacturer,and suppliers in India
This floor blower sends a low, wide stream of air across floors, walls and work areas, moving up to 300 CFM. A three-speed switch sets the airflow, and the four-position feet set the angle of the air stream. The housing is impact-resistant ABS, and the 220 V motor has built-in overload protection.
Specifications
| Supply | 220 V, single phase, 50 Hz |
| Speed switch | 3 speeds (high, medium, low) |
| Airflow | Up to 300 CFM |
| Overload protection | Built in |
| Housing | Impact-resistant ABS |
| Feet | 4-position adjustment |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Lab Exercises with the Blower Fan
In an HVAC or physics lab, students measure the air speed at the outlet on each of the three settings with the Handheld Anemometer Digital. Moving the anemometer back a step at a time shows how the stream slows and spreads with distance. Air speed multiplied by outlet area gives a rough airflow figure to set against the rated 300 CFM.
For a drying test, two wetted panels of wood or plaster are set out, one in the air stream and one in still air. Readings with the Moisture Meter, Portable every few minutes show how moving air speeds up drying. The same set-up is used to dry a floor after it has been washed with the Pressure Washer.
Frequently Asked Questions
What does 300 CFM mean?
CFM stands for cubic feet per minute, the volume of air the blower moves. 300 CFM is about 8.5 cubic metres of air a minute. Use the high setting for drying and the low setting where a gentle draught will do.
How is a floor blower different from a pedestal fan?
A pedestal fan spreads air around a room at head height. A floor blower sits low and sends a concentrated stream along the floor or up a wall, which is what dries floors, carpets and fresh plaster.
What do the four-position feet do?
They set the tilt of the blower. The air can then run flat along the floor or be aimed up at a wall, a ceiling or a panel being dried. Choose the position before switching on, with the blower on a firm surface.
What is the overload protection for?
An overload protector cuts power to the motor when it runs too hot or draws too much current, for instance when the air inlet is blocked. Keep the grilles clear of dust and paper so it does not trip.
How should the blower be cleaned?
Unplug it, then brush or vacuum dust from the inlet and outlet grilles. Wipe the ABS housing with a damp cloth rather than solvents, and store it with the cable coiled off the floor.
Other Cleaning and Drying Equipment
- Hand Blower
- Vacuum Cleaner (wet and dry)
- Integrated Coil Cleaning Machine
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
