Wire Stripper Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-12999
Jlab Export is a leading Wire Stripper Manufacturer,and suppliers in India
A wire stripper takes the insulation off the end of a wire without cutting the copper inside. This one strips solid wire from 10 to 20 AWG and stranded wire from 12 to 22 AWG. Picking the size that matches the conductor lets the blades cut through the insulation only, so the strands stay whole.
Specifications
| Solid wire | 10–20 AWG |
| Stranded wire | 12–22 AWG |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Wiring Practicals for Electrician Trainees
Electrician and electronics students strip dozens of wire ends in a single wiring board exercise. They cut each wire to length with a Side Cutting Plier, choose the stripper size for that wire and pull the insulation off in one movement. The bared end is then fitted with a terminal using the Crimping Tool, or tinned with a Soldering Iron for an electronics joint.
A teacher can check the work by looking for nicked or missing strands, the usual sign that the wrong size was used. Students can also compare a solid and a stranded wire of the same gauge in the stripper.
Frequently Asked Questions
Why are the solid and stranded ranges different?
A stranded wire is slightly larger across than a solid wire of the same gauge, because of the gaps between strands. So the stripping sizes differ. This stripper covers solid wire from 10 to 20 AWG and stranded wire from 12 to 22 AWG.
What do AWG sizes mean in mm²?
AWG is the American Wire Gauge, in which a higher number means a thinner wire. As a guide, 10 AWG is about 5.3 mm² in cross-section and 22 AWG is about 0.33 mm².
What happens if I use the wrong size?
Too small a size cuts into the copper and weakens the wire, and in stranded wire it cuts strands off. Too large a size does not cut through the insulation, so it tears and leaves a ragged end.
Can I strip a wire that is still connected?
Only after the circuit has been isolated and proved dead. Better still, strip wires before they are connected, then fit them to the terminals.
Other Electrical Hand Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
