Crimping Tool Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-12992
Jlab Export is a leading Crimping Tool Manufacturer,and suppliers in India
This electrical crimping tool presses terminals and cable lugs onto copper conductors from 0.5 to 6 mm². The crimp squeezes the terminal barrel and the wire into one tight joint without solder. It is the tool for finishing cable ends on panels, wiring boards and motor terminal boxes, and its handles are covered in nylon.
Specifications
| Type | Electrical crimping tool |
| Crimping size | 0.5–6 mm² |
| Handle | Nylon |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Wiring Practicals with Crimped Terminals
In an ITI electrician or wireman lab, trainees terminate cables onto a practice board. They strip each end with a Wire Stripper to the length of the terminal barrel. Next they slide on an insulated terminal, such as the Electrical Terminals in 2.5 or 4 mm², and crimp it. A firm pull on each joint shows whether the crimp holds.
The finished leads are then checked end to end on the resistance range of a Multimeter Digital. Teachers can saw one crimped terminal open so the class sees how the barrel and strands have been pressed together.
Frequently Asked Questions
What wire sizes can this tool crimp?
It covers conductors from 0.5 to 6 mm². Choose a terminal made for the same conductor size, so the barrel fits the wire closely before you squeeze it.
How much insulation should I strip?
Strip enough for the conductor to fill the terminal barrel, with its tip level with the barrel end or just past it. No bare copper should show between the insulation and the terminal sleeve.
Should a crimped terminal also be soldered?
No. A crimp is a cold joint made by pressure. Solder can run up the strands and stiffen them, so the wire may break at that point when it vibrates.
How can I tell a good crimp from a bad one?
A good crimp is pressed evenly, with no loose strands outside the barrel, and it does not move when you pull the wire hard. A loose or cracked terminal should be cut off and replaced with a new one.
Other Cable Termination Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026