Ball Peen Hammer Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-12978
Jlab Export is a leading Ball Peen Hammer Manufacturer,and suppliers in India
The ball peen is the fitter’s hammer. Its flat face strikes centre punches and cold chisels, and the rounded peen at the back spreads metal, closes rivets and rounds off edges. This one weighs 450 g and is made of alloy steel.
Specifications
| Weight | 450 g |
| Material | Alloy steel |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Riveting and Punching Workshop Exercises
A riveted lap joint is a standard ITI fitting job. Students mark two mild steel strips, dot the hole centres with the Punch Tool and drill them. A solid rivet goes through both, and the Rivet Set draws the strips together over it. The tail is then spread with the ball end and shaped into a round head.
Students also straighten bent strip on the Anvil With Stand with the flat face. Teachers can also show peening. A row of light, overlapping blows from the ball end along one edge stretches that edge. The strip then bends into a curve with that edge on the outside.
Frequently Asked Questions
What is the ball end of the hammer for?
It spreads and shapes metal. Fitters use it to form the head on a solid rivet, to peen a surface or an edge, and to round off the corners of a part. It is not meant for striking punches or chisels.
Which face should strike a punch or chisel?
The flat face, landing square on the head of the tool. A glancing blow can slip off and hurt the hand holding the punch, so watch the point of the punch and keep the hammer face clean and dry.
What work suits a 450 g head?
Centre punching, riveting small rivets, light chipping with a cold chisel and general bench work. It is close to the common 1 lb fitting hammer. Heavy chisel work in brick or thick bar calls for a club hammer.
Can I strike one hammer against another?
No. Hammer faces are hardened, and two hard faces meeting can chip and throw sharp splinters. Strike only the work, a punch or a chisel, and wear safety glasses at the bench.
Other Hammers for Metal and Wood
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026