Screwdriver Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-12956
Jlab Export is a leading Screwdriver Manufacturer,and suppliers in India
When a cross-recess screw sits behind a flange, under a shelf or close to a wall, a straight handle has no room to line up with it. This angled cross-head screwdriver gets round the problem. It is chrome vanadium steel, in one size, 2.5 x 100 mm.
Specifications
| Tip type | Cross-head |
| Form | Angled |
| Material | Chrome vanadium steel |
| Size | 2.5 x 100 mm |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Exercises in Cramped Spaces
Trainees fit a cover plate to a trainer board or a switch box where a bracket blocks the straight approach to one screw. The angled driver turns that screw while the nut behind it is held with a spanner from the Combination Spanner Set.
In panel wiring, students trim cable ties and wire ends with the Side Cutting Plier before closing the panel cover with its cross-head screws. Teachers can time the same job with a straight driver and with the angled one, to show where each tool belongs.
Frequently Asked Questions
How do I use an angled screwdriver?
Seat the tip squarely in the cross recess, press it in and turn the handle through the short arc the space allows. Lift, re-seat and repeat until the screw is tight. A fully seated tip on every stroke stops it rounding the recess.
Which screws does the 2.5 x 100 mm size suit?
It suits small cross-recess screws such as those on cover plates, switch boxes and appliance panels. The 100 mm length gives reach past a flange or a bracket. For larger recesses, use a straight driver with a bigger tip.
When is an angled driver better than a straight one?
Use it only when the space behind the screw blocks a straight handle. A straight driver turns faster and puts more inward pressure on the screw, which cross recesses need. The angled one is the answer for screws a straight tool cannot line up with.
Does it fit Pozidriv screws as well as Phillips?
It is a Phillips tip. Pozidriv screws look similar but have four extra fine lines between the arms of the cross, and their recess has straighter sides. A Phillips tip in a Pozidriv screw cams out and damages the head, so check the marks before you turn.
Other Screwdrivers and Spanners
- Screwdriver (angled flat-tip type)
- Screwdriver (magnetic cross-head, seven sizes)
- Straight Ratchet Ring Spanner Set
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
