Flare Fitting Set Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-13043
Jlab Export is a leading Flare Fitting Set Manufacturer,and suppliers in India
This set gives one brass flare fitting in each of five sizes: 8, 10, 12, 14 and 16 mm. It suits a training bench where students flare tubes of different sizes and need a matching fitting for each. Flare fittings seal on a flared tube end held by a flare nut, so the joint can be opened again.
Specifications
| Material | Brass |
| Pieces | 5 |
| Sizes | 8, 10, 12, 14 and 16 mm, one piece each |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Flaring Practicals with the Fitting Set
Each size in the set gives one practice joint. Students cut short lengths of copper tube with a Tube Cutter and deburr the ends with a Reamer. They slip a flare nut on and flare the end with a tool that has dies for metric tube. The nut is run up by hand before the final turn with two spanners.
Every joint is then pressurised with a Nitrogen Pressure Test Kit and brushed with Bubble Solution For Leak Detection. A flare that leaks is cut off and remade, so students learn to judge a good flare by its even, smooth face.
Frequently Asked Questions
What does the set contain?
Five brass flare fittings, one each in 8, 10, 12, 14 and 16 mm. The set is sold as one unit, so a single order covers all five sizes.
Why does a flare crack when the nut is tightened?
Usually the tube end was not cut square, was not deburred, or the flare was made too large or too thin. Soft annealed copper flares most cleanly. Re-cut the end and make a new flare rather than tightening harder.
Is a drop of oil needed on the flare?
A drop of refrigeration oil on the flare face and nut threads lets the nut turn smoothly and seat the flare evenly. Use the oil type that matches the system, so it does not contaminate the charge.
How tight should a flare nut be?
Tight enough to seat the flare without thinning it. A torque wrench set to the value for the tube size gives the same result every time. Without one, tighten firmly with two spanners and check with bubble solution.
Other Flaring Items
- Copper Pipe (6 and 8 mm rolls)
- Copper Pipe (14 and 16 mm rolls)
- Union
- Flare To Solder Fitting
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
