Tube Cutter Manufacturer,Supplier and Exporter in India
Product Code : EL-AELE-12894
Jlab Export is a leading Tube Cutter Manufacturer,and suppliers in India
Copper, aluminium, thin stainless steel and PVC tube from 6 mm to 42 mm outside diameter can all be cut with this heavy-duty tube cutter. One tool therefore covers small refrigeration lines and the larger pipe used in air conditioning and plumbing work. The frame is aluminium, which keeps a cutter of this capacity light to hold.
Specifications
| Type | Heavy-duty tube cutter |
| Body | Aluminium |
| Cuts | Copper, aluminium, thin stainless steel and PVC tube |
| Cutting range | 6–42 mm outside diameter |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Pipe Cutting Practicals for Students
A wheel cutter does not saw through tube. It scores a groove that gets deeper each time the feed is tightened and the cutter is turned round the tube. Students first measure the tube with a Digital Caliper, mark the length and set the wheel on the mark. They then cut lengths of Copper Pipe, feeding the wheel in a little after every turn.
Each cut end is cleaned up with the Reamer before the tubes are joined. Teachers can have one group cut aluminium or PVC tube and compare how much feed each material takes. A good cut is square, round and free of a heavy inside lip.
Frequently Asked Questions
What sizes of tube will this cutter take?
Anything from 6 mm to 42 mm outside diameter. For small copper in a tight corner the mini Tube Cutter is easier to swing, and capillary tube needs its own cutter so the bore is not pinched.
Can it cut stainless steel and plastic pipe?
Yes, within limits. It is made for copper, aluminium, thin-wall stainless steel and PVC. Stainless steel is harder on the wheel, so feed it in more gently. Use light pressure on PVC as well, or the soft wall can be pushed out of round.
How tight should the feed be turned?
Only enough for the wheel to bite. Bring it up to the tube, turn the cutter once, then tighten a little more before the next turn. Forcing the wheel squeezes soft copper oval and rolls a large burr into the bore.
Do the cut ends need any finishing?
Yes. Cutting leaves a raised burr round the inside edge and a sharp outer edge. Ream the inside, take the sharp edge off the outside, and clean the end before it is flared, swaged or brazed.
Other Tube Cutting and Finishing Tools
- Capillary Tube Cutter
- Copper Pipe Cutter (small cutter with fold-away deburrer)
- Deburring Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
