Reamer Manufacturer,Supplier and Exporter in India
Product Code : EL-AELE-12899
Jlab Export is a leading Reamer Manufacturer,and suppliers in India
After a tube cutter has done its work, the cut end carries a burr on the inside edge and a sharp lip on the outside. This inner and outer reamer takes off both on tubing from 3/16 in to 1 1/2 in outside diameter. The inside burr matters most, because it narrows the bore and disturbs the flow of refrigerant or water.
Specifications
| Type | Inner and outer reamer |
| Tube range | 3/16 in to 1 1/2 in outside diameter |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Practicals in Preparing Tube Ends
Students cut two pieces from the same Copper Pipe with the heavy-duty Tube Cutter and ream only one of them. Holding both up to the light shows how much of the bore the burr takes up. The reamed end then goes into a socket and is brazed with Brazing Rod.
A second exercise is reaming technique. The tube is held with its open end pointing down, so chips fall out instead of into the bore. Teachers explain that loose copper chips travel with the refrigerant and can block a capillary tube or lodge in a valve.
Frequently Asked Questions
What tube sizes does the reamer cover?
Tubing from 3/16 in up to 1 1/2 in outside diameter. That spans the small lines on refrigerators and the larger copper used in air conditioning and plumbing, so one reamer serves most of a training workshop.
Why ream the inside of a cut tube?
The cutter wheel rolls a lip of metal into the bore. Left in place, it restricts flow, adds turbulence and can stop a flare from seating on its fitting. Reaming restores the full bore.
Do I need to ream the outside edge as well?
Yes, lightly. The outer blade takes off the sharp edge so the tube slides into a fitting or flare nut without catching. Take off only the burr, because heavy reaming thins the wall at the end.
Which is better for tube ends, this or a blade deburrer?
This reamer is made for tube ends and works on the inside and outside edges. The Deburring Tools kit, a handle with HSS blades, suits holes and edges on plate and fittings, where a reamer cannot reach.
Other Tube End and Cleaning Tools
- Copper Fitting Brush
- Abrasive Strip (Sand Paper)
- Eccentric Flaring Tool (kit with reamer and cutter)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
