Grease Gun Manufacturer,Supplier and Exporter in India
Product Code : EL-AELE-9385
Jlab Export is a leading Grease Gun Manufacturer,and suppliers in India
Steering joints, kingpins and propeller shaft universal joints on many vehicles take grease through small nipples, and a hand grease gun pushes it in. This chrome-plated gun holds about 500 cc and delivers at about 4500 psi (310 bar). It is about 352 mm long.
Specifications
| Capacity | About 500 cc |
| Delivery pressure | About 4500 psi (310 bar) |
| Burst pressure | About 10000 psi (690 bar) |
| Finish | Chrome plated |
| Size | About 352 mm long x 62.5 mm |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Lubrication Practicals for Students
In a vehicle servicing lesson, students read the lubrication chart, find each grease nipple and wipe it clean. They fit the nozzle straight onto the nipple and pump until fresh grease just shows at the joint seal, then wipe off the surplus. On the Model Steering Jeep With Stub Axle, the class can trace the tie rod and stub axle joints that take grease on older vehicles.
The same service lesson usually includes an oil and filter change with the Oil Filter Wrench. Teachers can also use the gun to explain how a small push on the lever builds a high pressure. The lever drives a small plunger, and pressure is force divided by area.
Frequently Asked Questions
How do I load grease into the gun?
Unscrew the barrel from the head, pull the plunger rod back and lock it, then fill the barrel with grease. Refit the head, release the rod and pump the lever until grease flows from the nozzle.
What should I do if the gun pumps air instead of grease?
An air pocket in the barrel stops the flow. Loosen the head slightly, push the plunger rod in to drive the air out, then tighten the head again. Pump a few strokes onto a rag before going back to the nipple.
How much grease should go into a joint?
Pump slowly and stop once fresh grease starts to show at the seal or the old grease is pushed out. Too much can burst a rubber boot. The vehicle lubrication chart gives the points and the intervals.
Why will a grease nipple not take grease?
Usually the small ball inside the nipple is stuck with dirt or hardened old grease, or the passage behind it is blocked. Clean the nipple and try again. If it still refuses, replace it. Never hold a finger near the nozzle while pumping, as grease under this pressure can pierce the skin.
Other Vehicle Service Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
