Battery Plier Manufacturer,Supplier and Exporter in India
Product Code : EL-AELE-9387
Jlab Export is a leading Battery Plier Manufacturer,and suppliers in India
Battery terminal clamps are held by small nuts that sit close to the battery case, and these pliers are made for turning them. The serrated jaws grip the nut so it can be loosened or tightened when a terminal clamp is taken off or refitted.
Specifications
| Jaw | Serrated |
| Use | Loosening and tightening nuts on battery terminal clamps |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Battery Service Practicals
Students first learn the safe order for battery work. The negative clamp comes off first and goes back last, so a tool that touches the body cannot short the positive terminal. With the clamps off, they clean the posts and clamps, refit them and tighten the nuts with the pliers until the clamp cannot twist on the post.
The battery is then checked. A Battery Hydrometer reads the specific gravity of the electrolyte in each cell of a flooded battery. A Battery Load Tester then shows how well the battery holds its voltage under load. Teachers can end with a jump-start exercise using the Booster Cable Set.
Frequently Asked Questions
Which battery terminal should I remove first?
Remove the negative clamp first and refit it last. Then, if the pliers touch the vehicle body while you work on the positive side, there is no circuit to short. Cover the positive post while it is exposed.
What are the serrated jaws for?
The serrations bite into the flats of the clamp nut, so the pliers do not slip off a worn or corroded nut. Students can turn the small nut in the tight space beside the battery case.
How tight should a battery terminal clamp be?
Tighten the nut until the clamp cannot be twisted on the post by hand, then stop. Too much force can distort the soft lead clamp or the post. A loose clamp causes hard starting and heat at the post.
Can the pliers be used on other nuts?
They are made for battery terminal clamp nuts. For general nuts and bolts, a spanner or socket of the right size grips better and is less likely to round off the corners.
Other Battery and Electrical Test Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
