Booster Cable Set Manufacturer,Supplier and Exporter in India
Product Code : EL-AELE-9397
Jlab Export is a leading Booster Cable Set Manufacturer,and suppliers in India
Booster cables carry current from a charged battery to a vehicle whose battery is too weak to crank the engine, so that it can be started. This set is rated at 90 amp and is approx. 10 ft long. The cables have a special rubber covering that keeps oil out and extends their working life.
Specifications
| Use | Jump-starting a vehicle with a weak battery |
| Capacity | 90 amp |
| Length | Approx. 10 ft |
| Cable covering | Special rubber that resists oil |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice with Booster Cables
In an ITI or polytechnic auto workshop, students learn the jump-start sequence on a training vehicle. The positive lead goes on the weak battery first, then on the charged one. The negative lead goes on the charged battery and, last of all, on bare metal on the engine of the stalled vehicle.
Loose or corroded terminal clamps often cause a no-start, so students first tighten the clamp nuts with the Battery Plier. After the engine starts, they put the weak battery on the Battery Quick Charger first, since a load test means little on a flat battery. Once it is charged, the Battery Load Tester shows whether it holds its voltage or has failed.
Frequently Asked Questions
In what order are booster cables connected?
Positive to the weak battery, then positive to the charged battery. Next, negative to the charged battery and finally to an unpainted metal point on the engine of the vehicle that will not start. Take the clamps off in the reverse order once the engine is running.
Why does the last clamp go on the engine and not on the battery?
A battery can give off hydrogen gas, and the last connection usually makes a small spark. Making it on the engine block, away from the battery, keeps that spark clear of the gas. The block is connected to the negative terminal through the earth strap.
What does the 90 amp capacity mean in practice?
It is the current the set is rated to carry. Cranking draws a heavy current, so let the charged battery feed the weak one for a few minutes first. Keep each cranking attempt short and let the cables rest between tries.
Is a 10 ft cable long enough?
At approx. 10 ft, the leads reach between two vehicles parked close together, nose to nose or side by side, without the vehicles touching. Route the leads away from fan blades, belts and hot exhaust parts before anyone starts the engine.
How should the cables be stored?
Wipe off oil and battery acid after use and check that each clamp still grips firmly. Coil the cables loosely without sharp kinks. If the rubber covering is cut through to the conductor, take the set out of use.
Other Battery Service Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
