Oil Filter Wrench Manufacturer,Supplier and Exporter in India
Product Code : EL-AELE-9386
Jlab Export is a leading Oil Filter Wrench Manufacturer,and suppliers in India
Spin-on oil filters are often too tight or too oily to turn by hand, so this wrench grips the filter canister and turns it off. It fits filters from 25 to 160 mm in diameter and suits all kinds of vehicles.
Specifications
| Filter diameter | 25–160 mm |
| Use | Removing spin-on oil filters on all kinds of vehicles |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Oil Change Practicals in the Workshop
The oil and filter change is one of the first service jobs in an ITI motor mechanic course. Students warm the engine, drain the sump, then turn the old filter anticlockwise with the wrench and catch the oil in a tray. They smear clean oil on the rubber seal of the new filter and fit it by hand, about three quarters of a turn after the seal touches.
The sump drain plug goes back in with the Torque Wrench, tightened to the figure in the service data. The same lesson often covers greasing the chassis points with the Grease Gun.
Frequently Asked Questions
Why check the old filter seal before fitting the new filter?
The rubber seal of the old filter sometimes sticks to the engine and stays behind. If the new filter goes on over it, the two seals cannot seal against each other. Oil can then pour out as soon as the engine starts. Always look at the mounting face and remove any old seal.
Should I tighten the new filter with the wrench?
No. Fit the new filter by hand after oiling its seal, then turn it about three quarters of a turn more once the seal touches. Overtightening makes the next removal hard and can damage the seal.
How do I remove a filter that will not turn?
Wipe the canister dry so the wrench cannot slip, set the wrench as close to the base of the filter as possible and turn anticlockwise with steady force. The base end is the strongest part and does not crush easily.
Which way do I turn to remove an oil filter?
Turn it anticlockwise, seen from the bottom end of the filter, as for any normal right-hand thread. Have a drain tray ready, because oil runs out as soon as the seal breaks.
Other Tools for Routine Vehicle Servicing
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
