Fiberglass Surveyors Tape Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-9227
Jlab Export is a leading Fiberglass Surveyors Tape Manufacturer,and suppliers in India
Surveyors and site engineers use a fiberglass tape to measure lines on the ground, where a steel tape would kink or rust in wet grass. This 10 m tape is 12 mm wide, coated with PVC over the fiberglass and wound into a coated steel case. It carries both metric and imperial graduations.
Specifications
| Length | 10 m |
| Tape width | 12 mm |
| Tape material | Fiberglass, PVC coated |
| Case | Coated steel |
| Graduations | Metric and imperial |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Surveying Practicals for Civil Students
In chain and tape surveying, students set a Ranging Rod at each end of a base line. They measure the line in tape lengths and peg the end of each length. Offsets to fences, trees and building corners are then taped at right angles to the line. The right angle is set out with an Optical Square.
A second exercise measures the same line with a Survey Chain and with the tape, then compares the totals. It shows how tension, sag and slope change a taped reading. Teachers can also have students survey the school grounds and plot the plan to scale in the classroom.
Frequently Asked Questions
Does a fiberglass tape stretch?
It stretches very little under a normal pull: far less than a cloth tape, though more than a steel tape. Pull it with the same steady tension each time. Keep it straight and clear of obstacles, as sag and slack add to the reading.
Should I choose a fiberglass or a steel tape?
Fiberglass is light and flexible, and it does not rust or kink when it gets wet or is stepped on, which suits field work. A steel tape holds its length better for close work such as setting out building lines.
How do I use the metric and imperial graduations?
The tape is marked in both systems. Read the scale your drawing or field book uses and stay with it for the whole survey. Mixing metres and feet in one set of notes is a common cause of plotting errors.
How do I measure a line longer than 10 m?
Range the line with rods first. Measure it in full tape lengths, marking the end of each length with a peg or arrow, then move the tape forward. Count the full lengths and add the last part length.
How should the tape be cleaned after site work?
Wipe off mud and water with a damp cloth as you wind it in, and let it dry before it goes into storage. Grit wound into the case wears the PVC coating and the graduations.
Other Tapes, Rules and Survey Tools
- Steel Tape (Measuring)
- Tape Measure (locking pocket tape)
- Folding Ruler
- Survey Compass
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
