• +91-85699-09696

Pitot Static Tube Set-Up Manufacturer,Supplier and Exporter in India

Pitot Static Tube Set-Up

Product Code : EL-FML-10027
Jlab Export is a leading Pitot Static Tube Set-Up Manufacturer,and suppliers in India

Pitot Static Tube Set-Up (code EL-FML-10027) measures the point velocity of water in a clear acrylic test section made for 1-inch pipe, using a copper or stainless steel Pitot tube fitted with a vernier scale to set its position across the bore. Readings at different flow rates are used to calibrate the Pitot tube and to plot the velocity profile across the pipe. This Pitot-tube velocity bench is made by JLab in Ambala, India.

Specifications

ParameterDetail
Pitot tubeCopper or stainless steel, fitted with a vernier scale
Test sectionClear acrylic, for 1" dia. pipe
Flow measurementMeasuring tank, 40 litres; electronic stopwatch
Sump tank70 litres
Water circulationFHP centrifugal pump
Control panelOn/off switch, mains indicator
UtilitiesSingle phase, 220 V AC, 0.5 kW; water supply and drain
Quality checkEach Pitot tube set-up is visually inspected before dispatch
Pack quantityEach (sold individually)
Minimum order quantity1 unit
Dispatch timeUsually 14–18 working days
Product codeEL-FML-10027
ManufacturerJain Laboratory Instruments Pvt Ltd (JLab) — OEM
Country of originIndia (made in Ambala, Haryana)

Velocity from the Head Difference

The Pitot opening faces upstream and takes up the stagnation head, while the static holes read the static head of the stream. The difference between them, h in metres of flowing water, is the velocity head, so the ideal point velocity is v = √(2gh). A real tube reads slightly differently, and calibration gives its coefficient C in v = C √(2gh).

Traversing for the Velocity Profile

The vernier scale sets the Pitot tip at measured distances from the pipe axis, so a traverse across the bore gives velocities from wall to wall at each flow rate. Integrating these point velocities over the pipe area and comparing the result with the discharge from the measuring tank calibrates the tube. In laminar flow the profile is a parabola with a centre velocity twice the mean; in turbulent flow, usual at these pump flows, it is much flatter, so the mean comes far closer to the centre value than the one-half found in laminar flow.

Related Flow Measurement and Energy Benches

Browse the Fluid Mechanics Lab range for similar benches; it belongs to Fluid Mechanics and Hydraulics Lab Equipment.

Request a Quote

Request a quotation through Add To Cart or the contact page, stating the quantity and the delivery address for the set-up.

Last updated: 30 October 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us