Spindle Moulder Feeder Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-9326
Jlab Export is a leading Spindle Moulder Feeder Manufacturer,and suppliers in India
A spindle moulder feeder is a motorised unit with driven rollers that pushes timber past the cutter at a steady rate. This feeder has four feed speeds of 4, 8, 11 and 22 m/min and rollers of 120 x 60 mm. It runs on a 1 hp motor for a 380 V, 50 Hz, three phase supply.
Specifications
| Feed speeds | 4, 8, 11 and 22 m/min |
| Roller size | 120 x 60 mm |
| Motor | 1 hp |
| Power supply | 380 V, 50 Hz, 3 phase |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Machine Shop Practicals for Students
In a wood machining shop, the feeder is set over the table of a Spindle Moulder Machine so its rollers press the stock against the fence and table. Students prepare the timber first on a Combination Surface Planer and Thicknesser. Every piece then has the same width and thickness and feeds evenly.
A useful exercise is to run one moulding with Spindle Moulder Cutters at two feed speeds and compare the finish. A slower feed gives more knife cuts along each length and a smoother surface. Teachers also show how the feeder lets a long run of mouldings be worked with the operator standing well clear of the cutter.
Frequently Asked Questions
Which feed speed should be used?
Slower speeds suit hardwood, deep cuts and wide profiles, where the knives need time to cut cleanly. Faster speeds suit light cuts in softwood and long runs. Compare test pieces to find the setting that gives a clean finish without burning or tearing.
How should the rollers be set on the work?
Angle the feeder slightly toward the fence so the rollers push the stock into it as well as forward. Lower the rollers until they press down a little onto the timber, enough to drive it without crushing the surface.
What power supply does the feeder need?
The motor is 1 hp and is wired for a 380 V, 50 Hz, three phase supply. The workshop needs a three phase outlet near the machine, fitted and checked by an electrician.
Why use a power feeder instead of hand feeding?
The feeder drives the timber at an even speed, which gives a more uniform finish along the full length. It also holds the stock down against the table and fence, so the operator stands back from the cutter during the cut.
Other Wood Machining Equipment
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
