Forstner Bit Set Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-9256
Jlab Export is a leading Forstner Bit Set Manufacturer,and suppliers in India
Forstner bits bore clean, flat-bottomed holes in wood and board, guided by their rim rather than a long point. This set has five bits of 15, 20, 25, 30 and 35 mm. Each bit is 90 mm long on a 10 mm shank and tungsten carbide tipped (TCT). It has a balanced centre point, two cutting edges and two spurs that score the rim in melamine-faced board.
Specifications
| Pieces | 5 |
| Diameters | 15, 20, 25, 30 and 35 mm |
| Total length | 90 mm |
| Shank | 10 mm diameter, 60 mm long |
| Centre point | TCT, precision balanced |
| Cutting edges | 2 TCT, precision ground (Z2) |
| Spurs | 2 TCT, negatively ground, for chip-free cuts in melamine boards |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice with Forstner Bits
In furniture and cabinet classes, students bore the cup holes for concealed hinges in cabinet doors, which take a 35 mm flat-bottomed hole. The door is clamped on the table of a Drill Press, and the depth is checked often so the bit does not break through the face.
Other exercises include counterbores for screw heads and washers, and overlapping holes that clear the waste from a mortise. A half hole on a board edge makes a neat pass for a pipe or cable. Small parts are held down with a G-Clamp, never by hand.
Frequently Asked Questions
Will the bits fit my drill?
The 10 mm shank fits any drill chuck that opens to 10 mm or more, on a drill press or a portable drill. A drill press gives the cleaner result because it keeps the bit square to the work.
What speed should I run them at?
Run larger bits slower than small ones. The 35 mm bit needs a much lower speed than the 15 mm bit, and too high a speed burns the wood and heats the carbide tips. Lift the bit to clear chips on deep holes.
What do the spurs do?
The two spurs cut the outline of the hole just ahead of the main cutting edges. They score the surface fibres or the melamine face, so the rim of the hole comes out clean without chipping.
How do I bore right through a board without splintering the back?
Bore until the centre point just shows on the far side, then turn the board over and finish from that side, using the small hole as a guide. Or clamp a scrap board under the work and bore into it.
How is this set different from the Forstner Bits Set?
Both hold five bits from 15 to 35 mm. This set is carbide tipped, with spurs for melamine-faced board and a 10 mm shank on every bit. The Forstner Bits Set comes packed in a wooden box.
Other Drill Bit Sets
- Dowel Drill Bit Set
- Center and Flat Drill Bits Set
- Drill Bit Set (drill and screwdriver bits)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
