All Geared Lathe Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-9173
Jlab Export is a leading All Geared Lathe Manufacturer,and suppliers in India
An all geared lathe drives its spindle through gears in the headstock, so the speed is changed with gear levers instead of by moving a belt. On this lathe the spindle nose carries a 3/4 in, 16 TPI thread and a Morse taper 1 (MT1) bore. The tailstock spindle takes Morse taper 0 (MT0).
Specifications
| Power transmission | Gear type (all geared headstock) |
| Spindle nose thread | 3/4 in, 16 TPI |
| Spindle nose taper | Morse taper 1 (MT1) |
| Tailstock spindle taper | Morse taper 0 (MT0) |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice on the Lathe
Facing and plain turning come first in most ITI and polytechnic courses. A short mild steel bar is held in a chuck, its end is faced, and it is turned to a set diameter. Students check the diameter between cuts with an External Micrometer and the step lengths with a Dial Caliper.
For turning between centres, each end of the bar is first given a centre hole. It is cut with a centre drill from the Center and Flat Drill Bits Set, fed in from the tailstock. The tailstock also feeds a twist drill from the Drills set along the axis of the work. Teachers use the gear levers to show why a small diameter is turned at a higher speed than a large one.
Frequently Asked Questions
How are the spindle speeds changed on an all geared lathe?
With the gear levers on the headstock. Each lever position puts a different pair of gears into mesh between the drive and the spindle. Stop the spindle before moving a lever, and turn the chuck slowly by hand if the gears do not slide into place.
What fits the Morse tapers on this lathe?
The spindle nose takes tooling with an MT1 shank, such as a centre for work between centres. The tailstock spindle takes MT0 shanks, for example a dead centre or a drill chuck arbor. The taper grips the shank by friction and holds it on the lathe axis.
What does the spindle nose thread mean for chucks and faceplates?
The nose has a 3/4 in, 16 TPI thread. A chuck or faceplate screws onto it directly or through a back plate with the same thread, so quote this thread size when you add workholding later.
How does a geared head differ from a belt-driven head?
A belt-driven lathe changes speed by moving the belt across stepped pulleys, which means opening a cover and slackening the belt. A geared head changes speed with levers, so students can switch between a roughing speed and a finishing speed in a few seconds.
What should students check before starting the lathe?
Take the key out of the chuck, lock the tailstock and the tool post, and check that the work is held firmly. Tie back long hair, roll up loose sleeves and wear safety glasses. Never measure the work or clear chips by hand while the spindle turns.
Other Lathes and Lathe Accessories
- Center Lathe Machine (light to extra heavy duty models)
- Lathe Machine
- CNC Lathe Machine
- Center Gauge (for grinding and setting screw cutting tools)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
