Hand Wire Wrapping Tools Manufacturer,Supplier and Exporter in India
Product Code : EL-CLE-9114
Jlab Export is a leading Hand Wire Wrapping Tools Manufacturer,and suppliers in India
Wire wrapping makes a solderless joint by winding bared wire tightly round a square-cornered terminal pin. These hand tools combine a stripper, a wrapper and an unwrapper in one, so the same tool strips the insulation, makes the wrap and takes it off again. They come as a set of two for 22, 24 and 30 AWG wire.
Specifications
| Functions | Stripper, wrapper and unwrapper combined |
| Pin sizes | 0.76 x 1.52 mm and 1.14 x 1.14 mm |
| Wire sizes | 22, 24 and 30 AWG |
| Supplied as | Set of two |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Electronics Lab Practicals with Wire Wrapping
In an electronics workshop, students build a small circuit, such as an LED driver or a logic gate tester, on a board fitted with wire-wrap pins. They cut each wire to length, strip the end with the tool and slide it into the wrapping bit. Turning the tool over the pin lays a tight coil, and a wrong connection is taken off with the unwrapper and redone without heat.
Teachers often have one circuit built three ways and compared. Students lay it out on the solderless board of a Bread Board Trainer, solder it with a Soldering Station and then wire wrap it. Heavier hook-up wire for power leads is stripped with a separate Wire Stripper.
Frequently Asked Questions
What does each part of the tool do?
The stripper takes the insulation off the wire end. The wrapping end holds the bare wire beside the pin and winds it on in tight turns as the tool is rotated. The unwrapper end turns the other way to take a wrap off.
Which wire sizes can be used?
The set of two covers 22, 24 and 30 AWG wire. Use solid wire, not stranded: the sharp corners of the pin bite into a solid conductor to make the contact.
Which pins do the tools fit?
They are made for pins of 0.76 x 1.52 mm and 1.14 x 1.14 mm cross-section. Before wrapping, check that the bit slides freely over the pin to the depth needed.
How can students tell a good wrap?
Look for close, even turns with no gaps or overlaps, and no bare end sticking out at the top. Many labs also ask for one turn of insulated wire at the bottom of the wrap, which takes up bending strain.
When is wire wrapping chosen over soldering?
It suits prototypes and boards that will change, because a joint can be unwrapped and remade with no heat and no flux. Soldering gives a smaller joint and is normally used on finished boards.
Other Electronics Hand Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
