Soldering Iron Manufacturer,Supplier and Exporter in India
Product Code : EL-CLE-9091
Jlab Export is a leading Soldering Iron Manufacturer,and suppliers in India
A copper soldering iron is heated in a flame and then carries its heat to the joint, so it needs no power point. This one is a straight pattern with a diamond tip and a wooden handle, and it weighs 450 g. Irons of this kind are used for seams in sheet metal.
Specifications
| Type | Non electric |
| Bit | Copper |
| Pattern | Straight, diamond tip |
| Handle | Wooden |
| Weight | 450 g |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Sheet Metal Practicals with the Iron
A standard sheet metal job is soldering a lap seam on a tinplate tray or box. Students heat the copper bit in the flame of the Blow Lamp and clean and tin its faces. They then draw the iron slowly along the seam, feeding Tin Lead Solder in front of it.
Teachers can set the joint beside one made with the electric Soldering Iron on a circuit board. Students then see why a long seam needs the stored heat of a heavy copper bit.
Frequently Asked Questions
How hot should the copper bit be?
Hot enough that solder melts at once and runs when it touches the tinned face, but never glowing red. An overheated bit burns off its tinning and scales, and then solder will not stick to it.
How do I tin a new or pitted bit?
File the faces near the tip back to bright copper while the iron is cold. Heat it, rub the faces in flux and coat them with a thin layer of solder. Tin them again whenever they turn dark.
Why is the iron so heavy?
The 450 g of copper stores heat, so one heating lasts for a run of solder along a seam. A light bit would cool after a short distance and need to go back in the flame more often.
Can it be used on circuit boards?
It is not meant for that work. Its large bit suits sheet metal seams. For component leads and pads on a board, use an electric iron with a small tip.
How should the wooden handle be treated?
Keep the handle out of the flame while the bit heats, and rest the hot iron on a stand or a brick, never on the bench top. Let it cool fully before putting it away.
Other Soldering and Desoldering Tools
- Soldering Iron (electric, heat resistant handles)
- Soldering Station (with temperature control)
- Desoldering Pump
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
