Wash Bottles (LDPE) Manufacturer,Supplier and Exporter in India
Product Code : EL-B-19
Jlab Export is a leading Wash Bottles (LDPE) Manufacturer,and suppliers in India
A light squeeze sends a jet of water or solvent from this wash bottle through a flexible delivery tube that can be aimed wherever it is needed. The bottle is made of translucent, unbreakable low density polyethylene, and its polypropylene tube is fitted in the cap. It comes in 125, 250, 500 and 1000 ml sizes.
Specifications
| Material | Low density polyethylene (LDPE), translucent |
| Delivery tube | Flexible polypropylene, fitted in the cap |
| Capacities | 125, 250, 500 and 1000 ml |
| Operation | Squeeze lightly to dispense |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Titration and Filtration Practicals
During an acid-base titration, students rinse the tip of the Burette (Acrylic) with the wash bottle. Near the end point they also wash drops from the inner wall of the Conical Flask (Polypropylene) into the solution. Distilled water does not change the amount of acid or alkali present, so the titre stays the same.
In gravimetric work, a fine jet washes a precipitate down the filter paper in an Analytical Funnel and rinses the last particles out of the beaker. Teachers show students how to aim the jet at the top edge of the paper. The precipitate then moves down into the cone and does not wash over the rim.
Frequently Asked Questions
Why does the bottle drip when it holds acetone or alcohol?
Volatile solvents give off vapour, and warmth from the room or your hand raises the pressure inside, pushing liquid up the tube. Loosen the cap briefly to release the pressure, keep the bottle away from heat and use a separate, labelled bottle for each solvent.
Is one large rinse as good as several small ones?
No. Several small rinses with fresh liquid each time remove more of what is left on a surface than one rinse of the same total volume. Use short jets, let each one drain, then repeat.
How do I rinse a burette before a titration?
Rinse it first with distilled water from the wash bottle, then with two or three small portions of the solution it will hold, draining each through the tip. This stops leftover water from diluting the titrant.
Can the delivery tube be pointed into narrow glassware?
Yes. The polypropylene tube is flexible. It can be bent and aimed into the neck of a flask, down the side of a funnel or at one spot on a filter paper.
Other Squeeze and Dropping Bottles
- Wash Bottles New Type (single piece, tube moulded into the bottle)
- Dropping Bottles (LDPE, small uniform drops)
- Aspirator Bottles (distilled water supply with a half-turn spigot)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 14 November 2026
