Tap Reseater Cutter Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-9349
Jlab Export is a leading Tap Reseater Cutter Manufacturer,and suppliers in India
When a tap still drips after a new washer goes in, the brass seat under the washer is usually pitted or grooved. A tap reseater cuts that seat flat again so the washer can close on a clean ring. This tool comes with 2 double bush sets, 2 cones and 4 cutters.
What the Reseater Includes
| Bushes | 2 double bush sets |
| Cones | 2 |
| Cutters | 4 |
| Use | Re-cutting worn valve seats in water taps |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Plumbing Practicals for ITI Trainees
Repairing a dripping tap is a standard job in the plumber trade. Trainees shut off and drain the supply, take off the handle with a screwdriver and unscrew the headgear with adjustable Spanners. They then inspect the old washer and the seat. If the seat is marked, they fit the reseater to the tap body with a bush or cone and turn the cutter until a bright, even ring shows.
For bench practice, a spare tap body can be held in a Bench Vice fitted with its fibre or copper grips, so the brass is not marked. Students reseat it, fit a new washer, reassemble the headgear on a test board of Basin Pillar Taps and check under pressure that the drip has stopped.
Frequently Asked Questions
What does a tap reseater do?
It re-cuts the valve seat inside the tap body, the ring the washer presses on to shut off the water. A damaged seat lets water pass even under a new washer, so reseating can save replacing the whole tap.
What comes with this reseater?
It comes with 2 double bush sets, 2 cones and 4 cutters. The bushes and cones locate the tool in the tap body over the seat, and the cutter on the spindle faces the seat when the handle is turned.
When should a tap be reseated rather than just given a new washer?
Reseat it when a fresh washer does not stop the drip, or when the seat shows pits, grooves or a worn ridge. A seat that looks smooth and even usually needs only the new washer.
How much of the seat should be cut away?
Only enough to leave a clean, flat ring all the way round. Give the cutter a few light turns, lift it out and look, then repeat if needed. Cutting too deep thins the seat and shortens the life of the tap.
Other Plumbing Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
