Flush Machine Manufacturer,Supplier and Exporter in India
Product Code : EL-RACLE-12780
Jlab Export is a leading Flush Machine Manufacturer,and suppliers in India
A flush machine pumps solvent through the lines and coils of an AC or refrigeration system to wash out oil, sludge and debris. A typical case is the clean-up after a compressor burnout. This unit circulates flush solvent at 16 L/min from a 10 l container. Its clear coiled hoses let the operator see the solvent as it comes back.
Specifications
| Pump flow rate | 16 L/min |
| Pump motor | 300 W, 1/4 hp |
| Power supply | 220–240 V, 50 Hz, 1.7 A full load |
| Flush container | 10 l |
| Hoses | 9 ft (3 m), flexible, clear and coiled |
| Connections | 1/4 in SAE, extra external container connection and external nitrogen bottle connection |
| Valve controls | Stainless steel ball valves |
| Pump details | Mechanical seal, PTFE gasket and mechanical filter on the suction side |
| Dimensions | 381 x 406 x 609 mm (15 x 16 x 24 in), 914 mm (36 in) high with handle extended |
| Mobility | Roll-away wheels and handle |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice: Flushing a System
A typical ITI or college practical starts once the refrigerant has been recovered. Trainees take the compressor, expansion device and drier out of the circuit and connect the machine across one coil or line set. They circulate A/C Flush Solvent until the solvent in the clear return hose runs clean. The suction filter keeps loose debris out of the pump meanwhile.
Next they push the remaining solvent out with dry nitrogen through the external nitrogen bottle connection. The gas comes from one of the Nitrogen Gas Cylinders through the regulator of the Nitrogen Pressure Test Kit. Last, they fit a new Filter Drier and evacuate the circuit with one of the Fast Vacuum Pumps before recharging.
Frequently Asked Questions
When does a system need flushing?
After a compressor burnout, when the oil type changes during a conversion, or when sludge or debris has spread through the lines. Flush the coils and line sets only, with the compressor, expansion device and drier out of the circuit.
Which solvent goes in the machine?
A solvent made for flushing AC and refrigeration circuits, such as JLab A/C Flush Solvent. Do not use water, petrol or general cleaners, which leave moisture or residue behind in the system.
How do I get the solvent out after flushing?
Push it out with dry nitrogen through the nitrogen bottle connection on the machine, with a regulator keeping the pressure low. Then evacuate the circuit to a deep vacuum to draw off any solvent vapour and moisture that remain.
Can the solvent be used more than once?
The machine circulates solvent from its 10 l container, and an extra external container can be connected. Solvent that returns dark or full of debris should be drained and replaced, and the used solvent disposed of as chemical waste.
What power supply does it need?
A 220–240 V, 50 Hz supply. The 300 W, 1/4 hp pump motor draws 1.7 A at full load, so an ordinary workshop socket can run it.
Other Clean-Up and Recovery Equipment
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026