Transparent Vinyl Tube For Condensate Pumps 10/14 Manufacturer,Supplier and Exporter in India
Product Code : EL-RACLE-12835
Jlab Export is a leading Transparent Vinyl Tube For Condensate Pumps 10/14 Manufacturer,and suppliers in India
Transparent vinyl tubing in the 10/14 size gives a condensate pump a wider discharge line than the 6/9 tube. It is round, clear and made for condensate pump outlets. Water flow and any build-up of slime stay visible along the whole run to the drain.
Specifications
| Size | 10/14 |
| Material | Vinyl |
| Colour | Transparent |
| Shape | Round |
| Used for | Condensate pumps |
| Minimum order quantity | 50 units |
| Dispatch time | Usually 3–5 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Practicals on Condensate Drain Lines
In an AC installation practical, students route this tube from the outlet of a Condensate Removal Pump to a drain point and clip it along a wall board. They raise the outlet end in steps and time the flow into a container with a Digital Stopwatch, which shows how lift reduces the rate.
The clear wall also suits a fault-finding exercise. The teacher puts a sag or a tight bend into the line, and students find it by watching where the water slows or stands. A split unit such as the Split Air-Conditioner gives a full installation to practise on.
Frequently Asked Questions
Can the tube run outdoors in cold weather?
Water standing in an outdoor run can freeze in frost and block the line, and the water then backs up to the pump. Keep any outdoor section short and falling steadily, so it drains empty after each run. Where frost is common, take the tube to an inside drain instead.
How is it different from the other condensate tube?
Only the size differs. This one is 10/14, while the Transparent Vinyl Tube For Condensate Pumps is the 6/9 size. Both are clear, round vinyl tubes for condensate pumps.
Can the tube carry condensate by gravity as well?
Yes, provided it falls steadily all the way to the drain with no rises or sags. Water standing in a low point grows slime and can back up into the drain pan.
How do I join the tube to the pump outlet?
Cut the end square, push it fully over the outlet and, if the fit is loose, add a small hose clip. Check the joint for drips after the first test run with clean water.
Other Split AC Parts and Pipework
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
