Screw Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-13078
Jlab Export is a leading Screw Manufacturer,and suppliers in India
These cross-head screws are 6 mm in diameter and 3 cm long, the smallest of our three sizes. The cross-shaped recess in the head keeps the driver tip centred, so the screw starts straight and the tip slips off less often than on a slotted head. They come 100 to a pack for everyday fixing jobs.
Specifications
| Head | Cross-head drive |
| Diameter | 6 mm |
| Length | 3 cm |
| Pack quantity | Pack of 100 |
| Minimum order quantity | 10 packs |
| Dispatch time | Usually 3–5 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice with Cross-Head Screws
These screws suit the wall fixing exercise in a fitting or carpentry shop. Students drill a brick panel, press in a plug that is larger than the screw, such as the 8 mm Fisher, and fix a small bracket. They drive each screw with a cross-head bit in the Yankee Screwdriver and check that the bracket sits tight and level.
A short measuring task fits the same lesson. Students read the thread diameter and the length with a Vernier Caliper 0-300 mm and compare the readings with the pack size. Length runs from the tip to the point where the head meets the work surface.
Frequently Asked Questions
What do 6 mm and 3 cm mean on a screw?
The first figure is the diameter, measured across the outside of the thread, and the second is the length. So this screw is 6 mm thick and 3 cm long.
Which screwdriver fits a cross-head screw?
Use a cross-head driver or bit whose point fills the recess fully. A point that is too small rocks in the recess and slips out, which chews up the head. Push firmly in line with the screw while turning.
Do I need a pilot hole?
In hardwood, near the end of a board or in metal, drill a pilot hole first. It stops the material from splitting and lets the screw start straight. The small twist drills in the Drills set suit this job.
Why does the driver keep slipping out of the head?
Usually the bit is the wrong size, worn, or not held in line with the screw. Change to a fresh bit of the right size and press harder. A cross recess is shaped to push the tip out when the turning force gets too high.
Other Screw and Fixing Items
- Screw (8 mm x 4 cm)
- Screw (10 mm x 5 cm)
- Screwdrivers (set of 4)
- Anchor Bolt
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
