Spray Booth System Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-9342
Jlab Export is a leading Spray Booth System Manufacturer,and suppliers in India
A spray booth gives the workshop one fixed place for spray painting, with the working face, filters and extraction fan built as a single unit. This booth has a working area 2000 mm wide and 2070 mm high. Its 1.5 kW fan moves 8500 m³ of air per hour through a 3.0 m² filter surface and out through the workshop wall.
Technical Details
| Working width | 2000 mm |
| Working height | 2070 mm |
| Filter surface | 3.0 m² |
| Extraction fan capacity | 8500 m³ per hour |
| Fan motor | 1.5 kW, 380 V, 50 Hz, 3 phase |
| Main extraction duct | 465 mm diameter |
| Extraction route | Through the workshop wall |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Spray Painting Practicals for Trainees
Painter and motor body repair trainees at an ITI usually start on flat steel test panels. They rub each panel down with a Sanding Block, wipe off the dust and spray a primer coat of Anti-Rust Paint inside the booth. Once it has dried, the top coat goes on with a Spray Gun run from an Air Compressor.
Instructors set short exercises on gun distance, overlap between passes and travel speed. Students then judge each panel for runs, sags, dry spray and thin patches. A second exercise compares one heavy coat with two light coats on the same panel. Through every pass the fan draws the paint mist back into the filter face.
Frequently Asked Questions
What electrical supply does the spray booth need?
The fan motor is rated 1.5 kW for a 380 V, 50 Hz, three-phase supply. A single-phase socket will not run it, so arrange a three-phase point near the booth before it is installed.
How does the booth take the paint mist out of the room?
The extraction fan pulls air from the working face through the 3.0 m² filter surface, where the overspray collects. The air then leaves by the 465 mm main duct, which passes out through the workshop wall. Plan a wall opening for the duct when choosing where the booth will stand.
How often should the booth filters be changed?
That depends on how much paint is sprayed. Look at the filter face before each session and change the filters once they are loaded with paint and the pull at the opening feels weak. Spraying with clogged filters lets mist drift back into the workshop.
What size of work fits in the booth?
The working opening is 2000 mm wide and 2070 mm high. Test panels, cabinet doors and small furniture can stand upright on a stand inside it, with room for the sprayer to reach every edge of the work.
Other Painting and Surface Preparation Items
- Paints (red, blue, green, black and white)
- Electric Airless Paint Sprayer Gun
- Wire Brush (stainless steel bristles)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
