• +91-85699-09696

Electric Airless Paint Sprayer Gun Manufacturer,Supplier and Exporter in India

Electric Airless Paint Sprayer Gun

Product Code : EL-WWM-8613
Jlab Export is a leading Electric Airless Paint Sprayer Gun Manufacturer,and suppliers in India

This spray gun needs no compressor. A small electric pump in the gun pushes paint from the cup out through the nozzle, where it breaks up into a spray. The gun is rated 75 W, runs on 220 V, 50 Hz and draws 0.6 A. Its cup holds 600 ml, and it comes with a funnel and a user manual.

Specifications

Supply220 V, 50 Hz
Power75 W
Working current0.6 A
Cup capacity600 ml
PlugEU type
Size22 x 21 x 3.5 cm (8.7 x 8.3 x 1.4 in)
PackageElectric paint spray gun, user manual, funnel
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Finishing Practicals in the Paint Shop

Students prepare a set of wooden panels with the Orbital Sander Machine and wipe off the dust. They then spray in the Spray Booth System, which draws the paint mist away from them. Each student first sprays a test card to check the pattern, then coats a panel in even, overlapping passes.

In a fabrication class, the same gun puts a coat of Anti-Rust Paint on a welded steel frame before the finish coat. Teachers can compare it with an air spray gun on a compressor and let students judge the finish, the overspray and the time spent cleaning up.

Frequently Asked Questions

Does this paint sprayer need an air compressor?
No. An airless sprayer puts the paint itself under pressure with a pump inside the gun, so no compressed air is used. All it needs is a mains supply of 220 V, 50 Hz.

Do I need to thin the paint?
Thick paints usually need some thinning before they will spray well. Follow the paint maker’s advice for spray use and thin in small steps. Fill the 600 ml cup through the funnel so no paint runs down the outside of the gun.

How do I get an even coat?
Hold the gun square to the surface at a steady distance. Start moving before you pull the trigger and keep moving until after you release it. Overlap each pass by about half its width, and put on two thin coats instead of one thick one.

How is the gun cleaned after use?
Empty the cup, then spray clean water or the right thinner through the gun until it comes out clear. Wipe the nozzle and cup and let them dry. Strip and clean other parts as the user manual shows, and never leave paint drying inside.

What plug and supply does it use?
The gun is made for 220 V, 50 Hz and has an EU type plug. Where the sockets are of another type, use a properly rated plug adaptor. Do not run it on a supply of a different voltage.

Other Painting and Finishing Equipment

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us