• +91-85699-09696

Orbital Sander Machine Manufacturer,Supplier and Exporter in India

Orbital Sander Machine

Product Code : EL-WWM-8618
Jlab Export is a leading Orbital Sander Machine Manufacturer,and suppliers in India

An orbital sander moves its flat pad in small circles, so the abrasive works the surface without the long scratches a belt can leave. This portable machine has a 115 x 225 mm pad on a 6 mm sanding stroke. A 230 V single-phase AC motor drives it at 3000 rpm. It is used for sanding and polishing veneers, wood and sheet metal.

Specifications

TypePortable electric orbital sander
Motor230 V, 1 phase AC
Sanding stroke6 mm
Pad size115 x 225 mm
Speed3000 rpm
UsesSanding and polishing veneers, wood and sheet metal
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Finishing Practicals for Students

A basic exercise is preparing a veneered or solid panel for finishing. Students draw light pencil lines across the face and sand with coarse paper until the lines are gone. They repeat this with medium and then fine paper, so each grade removes the scratches of the one before. The panel is then sprayed with the Electric Airless Paint Sprayer Gun.

Teachers can sand one end of a board on the Disc Sander and the other end with this machine, then show both under a low, raking light. The disc leaves curved marks across the grain, while the orbital finish is much finer. Students also rub down primed steel sheet between coats before the top coat goes on with the Spray Gun.

Frequently Asked Questions

What does the 6 mm sanding stroke mean?
It is the size of the small circle the pad moves through. A bigger stroke removes wood faster but leaves a coarser scratch pattern. A smaller one cuts more slowly and leaves a finer surface, which is what a finishing sander is for.

How hard should I press on the sander?
Only lightly. Let the weight of the machine do most of the work and keep the pad flat on the surface. Pressing hard slows the pad, heats the paper and leaves swirl marks. Move slowly in overlapping passes along the grain.

Which abrasive sheets fit the pad?
Use sheets cut to suit the 115 x 225 mm pad, fitted tight so they do not ripple. Change the sheet as soon as it clogs or stops cutting, because a worn sheet only polishes and heats the surface.

Can it be used on metal as well as wood?
Yes. It sands and polishes sheet metal as well as veneers and wood. Use abrasive made for metal, and blow or brush the metal dust out of the machine before going back to woodwork.

When should I use a belt sander instead?
A belt sander removes material quickly on large flat surfaces, but its straight scratches are deep. Use it for levelling, then switch to the orbital sander for the final finish before painting or polishing.

Other Sanders in the Range

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us