Belt Sander Portable Pipe Polishing Machine Manufacturer,Supplier and Exporter in India
Product Code : EL-WWM-8666
Jlab Export is a leading Belt Sander Portable Pipe Polishing Machine Manufacturer,and suppliers in India
Round stainless steel tube is hard to finish with a flat sander, and this portable pipe polishing machine is built for that job. Its narrow 620 x 40 mm belt follows the curve of a pipe or tube for polishing, satin finishing and rust removal. The 800 W motor runs from 700 to 3000 rpm, and the machine weighs 4.0 kg.
Specifications
| Use | Sanding and polishing stainless steel tube and pipe |
| Voltage | 110 V or 220 V |
| Power | 800 W |
| No-load speed | 700–3000 rpm |
| Sanding belt | 620 x 40 mm |
| Net weight | 4.0 kg |
| Jobs | Surface treatment, tube and curved-surface polishing, satin (wire drawing) finish, rust removal |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice in Tube Finishing
In a fabrication class, students cut stainless tube to length with a Hacksaw and hold it in a Pipe Vice for finishing. A welded handrail joint is first ground nearly flush with an Angle Grinder. The pipe sander then blends the joint into the tube with a coarse belt, followed by finer belts.
A second exercise is cleaning a rusty mild steel pipe before painting. Half the pipe is done with a Wire Brush and half with the belt, so students can compare the two surfaces. Teachers can also show how a satin finish depends on steady strokes in one direction.
Frequently Asked Questions
Should I order the 110 V or the 220 V version?
Choose the one that matches the mains supply in your workshop. A tool run on the wrong voltage either lacks power or overheats its motor. Tell us the voltage when you send your enquiry.
What is a wire drawing finish?
It is another name for a satin or brushed finish: fine, even lines left by the abrasive, as seen on stainless handrails. Use a fine belt, a steady speed and strokes in one direction, so the lines stay straight and even all round.
When should I use a low or a high speed?
Work near 3000 rpm to take off weld marks, scale and rust quickly. Drop towards 700 rpm for final polishing and on thin-wall tube. Too much heat can discolour stainless steel and leave a straw or blue tint.
What belts does it take?
It takes 620 x 40 mm sanding belts. Keep a few grits ready: a coarse belt for blending welds and removing rust, a medium belt, and a fine belt for the satin or polished finish.
Other Metal Finishing Tools
- Belt Sander (heavy-duty machine for metal parts)
- Portable Angle Grinder
- Wire Brush Set (cup and end brushes)
- Abrasive Strip (Sand Paper)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
