Power Hand Drill Manufacturer,Supplier and Exporter in India
Product Code : EL-WWM-8625
Jlab Export is a leading Power Hand Drill Manufacturer,and suppliers in India
Two drilling modes, plain rotary and impact, let this power hand drill go from timber and steel to brick in the same lesson. It draws 600 W, runs at 1250 rpm with no load and has a 10 mm capacity. It weighs 2.1 kg, and the side handle swings through 360 degrees so a second hand can steady it at any angle.
Specifications
| Drilling modes | Regular drilling and impact drilling |
| Capacity | 10 mm |
| Power input | 600 W |
| No-load speed | 1250 rpm |
| Weight | 2.1 kg |
| Side handle | Heavy duty, adjustable through 360 degrees |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice with the Power Hand Drill
In a fitting class, students mark hole centres on a mild steel strip and dot them with a Punch Tool so the bit cannot wander. The strip goes into a Bench Vice. With impact switched off, they drill pilot holes and then open them out with bits up to 10 mm from the HSS Universal Drill Bit Set.
Electrical and plumbing trainees then switch to impact and drill a brick or block wall for wall plugs, using a bit from the Masonry Drill Bit Set. Teachers can let them try the same wall with impact off, so they hear and feel why the hammer action is kept for masonry.
Frequently Asked Questions
When should I use the impact mode?
Only on masonry such as brick, block and concrete, and only with a masonry bit. The impact action knocks the turning bit forward and chips the material out. Keep it off for wood, metal and plastic, where it blunts HSS bits and leaves a rough, oversize hole.
What does the 10 mm capacity mean when choosing bits?
Keep bits and holes at 10 mm or under. For a larger hole in steel, move the work to a bench or pillar drill. In any material, a small pilot hole first makes the bigger bit start true and cut with less force.
How do I set the side handle?
Loosen its clamp, swing the handle round to the angle that suits your stance and the hole, then tighten it again. Use it with your second hand whenever impact is on or the bit is large, so the drill cannot twist in your grip if the bit catches.
Is 1250 rpm suitable for both wood and steel?
That figure is the speed with no load, and it falls once the bit is cutting. Small bits in wood cut cleanly at full speed. In steel, press firmly and steadily, add a drop of cutting oil, and ease off if the chips turn blue.
Other Drills in the Workshop Range
- Rotary Hammer Drill (SDS-plus chuck, for heavier concrete work)
- Portable Drill Machine
- Portable Electric Drill (corded, variable speed, in a case)
- Drill Press (bench type)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
