Disc Sander Manufacturer,Supplier and Exporter in India
Product Code : EL-WWM-8673
Jlab Export is a leading Disc Sander Manufacturer,and suppliers in India
Built around a single 12 in disc, this disc sander trues the ends, mitres and bevels of small and medium parts. A 1 HP, 110 V motor turns the disc at 1725 rpm. The 17-1/4 x 8-1/4 in cast aluminium table tilts from 0° to 45°. A cast iron base on rubber feet keeps the compact machine steady on a bench.
Specifications
| Disc | Takes 12 in PSA (self-adhesive) abrasive discs |
| Motor | 1 HP, 110 V, single phase, 10 A, TEFC |
| Speed | 1725 rpm |
| Table | Cast aluminium, 17-1/4 x 8-1/4 in, tilts 0° to 45° |
| Mitre gauge | Included |
| Base | Cast iron, built-in 2 in dust port, non-slip rubber feet |
| Switch | Toggle on/off |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Practicals on the Disc Sander
For a box or a small frame, students cut the parts a little over length on the Mitre and Table Saw. They then sand each one to its marked line against the disc, with the mitre gauge holding it square. A Steel Rule shows when matching parts have come to the same length.
With the table tilted, the same class can sand an even bevel round the edge of a lid. Corners are checked with a Square after each pass. Teachers can show how a light, moving feed keeps the disc cool, while a heavy push burns the wood and clogs the abrasive.
Frequently Asked Questions
What are PSA discs, and how is one changed?
PSA means pressure-sensitive adhesive: the abrasive disc has a peel-off sticky back. Peel the worn disc away, clean any adhesive left on the plate, then press a new 12 in disc on, centred and smooth, before switching on.
What does TEFC mean on the motor?
It stands for totally enclosed, fan cooled. The windings are sealed inside the motor housing and an outside fan blows air over the casing. Fine sanding dust therefore stays out of the motor itself.
How are bevels and mitres set?
Tilt the table anywhere from 0° to 45° for a bevel along an edge or end. For an angle across the face, keep the table flat and set the mitre gauge instead. Sand a trial piece and check it before doing the batch.
Can a dust extractor be connected?
Yes. The cast iron base has a built-in 2 in dust port for a workshop vacuum or extractor hose. Empty the collector often, because fine sanding dust fills it faster than chips from sawing do.
Other Sanding Machines
- Disc Sander Belt (4 x 36 in belt and 6 in disc)
- Portable Drum Sander
- Orbital Sander Machine
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
