• +91-85699-09696

Portable Planer Manufacturer,Supplier and Exporter in India

Portable Planer

Product Code : EL-WWM-8677
Jlab Export is a leading Portable Planer Manufacturer,and suppliers in India

An electric hand planer saves a long session with a bench plane when a door edge or a board has to be shaved down. This portable planer spins a two-blade cutter head at 16,500 rpm on a 6.5 A motor. One turn of its ratcheting depth knob covers the whole 0 to 3/32 in range, and the chips can be thrown to either side.

Specifications

Motor6.5 A
No-load speed16,500 rpm
Blades2-blade system, convertible to high-speed steel blades
Depth of cut0 to 3/32 in, set by a ratcheting knob in one turn
Chip ejectionLeft or right
Bevel guide fence0° to 45°, with a shield over the unused part of the blade
Park restSpring-loaded
SwitchAmbidextrous lock-off release button
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Workshop Practice with the Portable Planer

A typical carpentry exercise is fitting a door or drawer front to its opening. Students plane the edge down to a pencil line in steady passes. They check it for straightness with a Steel Rule held on edge and for squareness with a Square.

Pressing on the front of the planer at the start of a pass and on the back at the end stops it dipping at the ends. With the bevel fence set to 45°, the same class can plane a chamfer along a table edge. Teachers can then compare the result with a surface trued by hand with a Fore Plane.

Frequently Asked Questions

How much wood can it take off in one pass?
Up to 3/32 in. The ratcheting knob covers the full depth range in one turn, so there is no need to re-zero it. For a clean surface, take off most of the waste in deeper passes and finish with one light pass.

Which way do the shavings go?
Chip ejection can be set to the left or the right. Send the shavings away from yourself and from anyone working beside you. On a long job, choose the side where they are easiest to sweep up.

What does the park rest do?
The spring-loaded rest holds the blades clear when the planer is put down, which protects both the blades and the workpiece. Its shape also lets you start the planer in the middle of a board, not only from the end.

How do I plane a bevel?
Fit the bevel guide fence and set it anywhere from 0° to 45°. Keep the fence pressed against the face of the board for the whole pass. The shield on the fence covers the part of the blade that is not cutting.

Can it take high-speed steel blades?
Yes. It can be converted to use larger high-speed steel blades, which can be resharpened. Change both blades together as a pair, so the cutter head stays balanced and cuts evenly.

Other Planers and Planes

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us