Electric Router Manufacturer,Supplier and Exporter in India
Product Code : EL-WWM-8678
Jlab Export is a leading Electric Router Manufacturer,and suppliers in India
A plunge router lowers its spinning bit straight down into the wood and is then guided along to cut grooves, rebates, moulded edges and joints. This electric router has a 15 A, 1850 W motor running at 23,000 rpm, a 0 to 2-3/8 in plunge and a 1/2 in collet. It takes bits with 1/4 in or 1/2 in shanks.
Specifications
| Motor | 15 A, 1850 W |
| Supply | 110 V, 60 Hz |
| No-load speed | 23,000 rpm |
| Plunge capacity | 0 to 2-3/8 in |
| Collet | 1/2 in (12.7 mm) |
| Bit shanks | 1/4 in or 1/2 in |
| Depth setting | Top handle depth adjustment, 3 preset plunge depths |
| Other features | Shaft lock for bit changes, all ball bearing construction |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Joinery Practicals with the Router
A bookshelf side is a classic first project. Students mark the shelf housings with a Square and clamp a straight batten across the board with a G-Clamp at each end. The router base runs along the batten, and each housing is cut in stages using the three preset depths.
Later lessons cover a moulded edge on a table top and half-blind dovetails for a drawer. For the dovetails, the router follows the template of the Dovetail Machine, which clamps both boards and cuts tails and pins in one pass. Teachers can show what happens to the edge when the feed goes the wrong way.
Frequently Asked Questions
Can it use 1/4 in shank bits?
Yes. It takes 1/4 in and 1/2 in shank bits. The collet is 1/2 in, so a 1/4 in bit needs a collet or sleeve of its own size. Push the shank well in, draw it back slightly, then tighten the collet with the shaft lock engaged.
How do the three preset plunge depths help?
Cut deep grooves in stages. Set the three stops to a first, a middle and the final depth, then rout at each in turn. Each pass takes a light cut, which is easier on the bit and the motor and leaves cleaner walls.
Which way should the router be moved?
Against the spin of the bit. Seen from above the bit turns clockwise, so feed from left to right along an edge facing you. Go anticlockwise round the outside of a board and clockwise round the inside of a frame.
How deep can it cut?
The plunge runs from 0 to 2-3/8 in, set with the top handle depth adjustment. The usable depth also depends on the length of the bit and how far its shank sits in the collet. Never take the full depth in one pass.
What supply does it need?
It is rated for 110 V, 60 Hz. On higher-voltage mains it has to run through a step-down transformer rated for its 1850 W load. Check the supply before plugging it in.
Other Woodworking Tools and Machines
- Portable Planer
- Portable Jig Saw Machine
- Dowel Master (dowelling jig)
- Spindle Moulder Machine (floor machine for edge shaping)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
