Home » Our Product » Technical and Vocational Education and Training TVET » Standard Welding Equipment Set » Angle Grinder

Angle Grinder Manufacturer,Supplier and Exporter in India

Q: Why does the gear housing rotate?

Turning the head through 90 deg from its normal position changes where the switch and handles sit in relation to the disc. For cut-off work this lets you hold the tool comfortably with the disc upright.

Product Code : EL-SWES-8744
Jlab Export is a leading Angle Grinder Manufacturer,and suppliers in India

A 7 in angle grinder for weld preparation, grinding and cut-off work in the fabrication shop. It runs on 115 V AC or DC, draws 15 A and takes 7 or 9 in wheels when the matching guard is fitted. A spindle lock, soft start and a side handle that fits on either side are built in.

Specifications

Wheel diameter	7 in
Wheel options	7 or 9 in, with the correct guard
Supply	115 V, AC or DC
Current	15 A
Switch	On/off, with soft start
Spindle lock	Yes, for wheel changes
Gear housing	Rotates 90° for cutting
Handles	Back body grip and side handle, either side
Bearings	Ball and needle
Motor	Sealed with zig-zag anti-dust varnish
Minimum order quantity	10 units
Dispatch time	Usually 4–6 working days
Manufacturer	JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Workshop Practice: Bevelling, Grinding and Cutting

Before a butt weld, fabrication students hold the plate in a Bench Vice and grind a bevel along each edge, leaving a small flat root face. After welding they grind the cap flush on test strips, so the Bend Test Equipment checks the weld itself rather than the shape of the bead.

With a thin cut-off wheel and the gear housing turned through 90°, the grinder trims flat bar and angle to length on the bench. Students wear Grinding Goggles throughout and learn to keep the guard between the wheel and their body.

Frequently Asked Questions

Can I fit a 9 in wheel?
Yes, the grinder accepts 7 or 9 in wheels, but only with the guard made for that size. Check that the speed marked on the wheel is at least the grinder’s no-load speed before you fit it.

How do I change the wheel?
Unplug the grinder first. Press the spindle lock and turn the wheel until the lock engages, undo the flange nut, then fit the new wheel with the flanges the right way round. Tighten the nut and release the lock before switching on.

Why does the gear housing rotate?
Turning the head through 90° from its normal position changes where the switch and handles sit in relation to the disc. For cut-off work this lets you hold the tool comfortably with the disc upright.

What does the soft start do?
Soft start brings the motor up to speed gradually instead of all at once. The tool jerks less in your hands at switch-on, and the starting surge on the supply is lower.

What supply does it need?
It is rated 115 V and runs on AC or DC, drawing 15 A. Where the mains voltage is higher than 115 V, run it through a step-down transformer sized for that load.