Electric Stapler Manufacturer,Supplier and Exporter in India
Product Code : EL-WWM-8683
Jlab Export is a leading Electric Stapler Manufacturer,and suppliers in India
Mains-powered at 220–230 V, this electric stapler drives staples into wood and board without the hand squeeze a manual tacker needs. Its magazine holds 100 staples, and fasteners from 6 to 16 mm are recommended. A viewing window shows when the staples are running low. It is a portable tool, easy to take to on-site repairs.
Specifications
| Magazine capacity | 100 staples |
| Recommended fasteners | 6–16 mm |
| Power | 600 W |
| Operating voltage | 220–230 V |
| Controls | Power on/off switch, built-in safety trigger |
| Magazine | Loading and unloading catch, staple viewing window |
| Use | Portable tool, suited to on-site repairs |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Exercises in Upholstery and Fixing
An upholstered stool top is a good first project. Students cut a round plywood base with the Portable Jig Saw Machine and lay foam and fabric over it. They pull the fabric taut and staple from the middle of each side out towards the corners, so the cover stays even and free of wrinkles.
In a cabinet class, the stapler fixes a hardboard back to a carcass. Before stapling, students measure both diagonals with a Tape Measure, because equal diagonals mean the carcass is square. A Square confirms each corner.
Frequently Asked Questions
Which staple length should I use?
Fasteners from 6 to 16 mm are recommended. Use short staples for fabric, card and thin sheet on softwood. Choose longer ones to hold through foam, several layers of fabric or hardboard into a frame.
How is the stapler loaded?
Switch off and unplug it first. Open the loading and unloading catch, put a strip of staples into the magazine and close the catch again. The viewing window shows how many of the 100 staples are left.
Why do some staples stand proud of the surface?
The wood may be hard, the staple too long for it, or the nose not pressed flat. Hold the nose square and firm against the work before firing, and try a shorter staple in hardwood. Tap any proud staple flush with a light hammer.
What should I do if a staple jams?
Switch off and unplug the stapler. Open the catch, take out the strip and pull the bent staple from the nose with pliers. Check that the staples are within the recommended 6 to 16 mm before reloading.
Can it be used away from the workshop?
Yes. It is portable and suited to on-site repairs, running from a 220–230 V supply. On site, an Extension Cable Reel brings power to the job. Keep the cable clear of the work area.
Other Tools for Fixing Work
- Nailer Gun (compressed air, for nails)
- Screwdrivers (set of 4)
- Power Hand Drill
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
