Figure Stamp Set Manufacturer,Supplier and Exporter in India
Product Code : EL-CLE-9083
Jlab Export is a leading Figure Stamp Set Manufacturer,and suppliers in India
A figure stamp set is used to punch numbers into metal, for example job numbers, roll numbers or part sizes. This set has the figures 0 to 9 with a character height of 5 mm. It is kept in a plastic or sheet metal box.
Specifications
| Characters | Figures 0 to 9 |
| Character height | 5 mm |
| Box | Plastic or sheet metal |
| Use | Workshop marking |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice with Number Stamps
Students can stamp their roll number on each finished fitting job. They first scribe a straight baseline with a Single Ended Scriber against a Steel Rule. Each figure is then struck on the line so the digits sit level and evenly spaced.
The job should rest on a solid surface such as an Anvil With Stand, so the blow goes into the metal instead of a springy bench. Before an assembly is stripped, teachers can show how to stamp matching numbers on mating parts so they go back together the same way.
Frequently Asked Questions
How do I keep stamped figures in a straight line?
Scribe a light baseline first and set the bottom edge of each stamp on it. Hold the stamp upright, check the figure faces the right way and give one firm hammer blow. A second blow often leaves a double image.
What hammer suits these stamps?
A medium ball peen hammer or an Engineering Hammer suits 5 mm figures. One square blow gives a cleaner mark than several light taps. If the stamp head starts to spread over time, dress it back to shape.
Can the stamps mark hardened steel?
No. Number stamps are for mild steel, brass, aluminium and other soft metals. Striking hardened steel can chip the figure or crack the stamp.
How do I tell the 6 from the 9?
Each is the other turned upside down, so make a test mark on scrap before stamping the job. Many workshops add a dot or a short line under the 6 and the 9 to avoid mix-ups on finished parts.
Other Marking and Punching Tools
- Punch & Chisel Set (centre, solid, drift and pin punches)
- Wing Divider
- Engineers Square
- Vernier Height Gauge
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
